01432 610152 Get a quote Call 01432 610152

Concrete tile pitch

What pitch do concrete tiles need?

Concrete tiles have no one pitch. Marley's table runs from 12.5 degrees for its flattest tile to 35 for a plain concrete tile.

In brief

The minimum depends on the tile. Marley's published table gives 12.5 degrees for Mendip 12.5, 15 for Wessex, 17.5 for Edgemere, 22.5 for Double Roman, 25 for Anglia and 35 for the plain concrete tile. Several of its figures are for the smooth finish only, so the sheet that came with your own tile is the one to follow. Laid on a roof shallower than that minimum, any of them leaves wind free to drive rain back up the laps, however well the work is done.

Why one concrete tile needs more slope than another

Concrete roof tiles come in two broad families. Plain concrete tiles are small and flat, laid in overlapping courses much as clay plain tiles are. Interlocking tiles are bigger, with a profile and a side joint that lets each one lock into the next. The two shed water differently, and that is the reason their lowest pitches sit so far apart.

A small flat tile depends on steep fall and deep overlap, because the water has many joints to cross on the way down. A large profiled tile has deep channels that lead water away quickly, so it can work on a gentler slope, provided the manufacturer has tested it there.

Fit also affects the figure. A tile fitted at the minimum has no margin if the roof sags a little with age or the batten spacing is off. We therefore read the slope with a level on site, since pitch drawn on a plan and pitch actually in the roof can differ by a few degrees, and those few degrees decide whether a tile suits the roof.

Marley's published figures for concrete tiles

This is the minimum pitch Marley publishes for its concrete range. Where the finish is shown, the figure applies to that finish, and the data sheet governs. Marley's page also says to check that sheet before choosing a tile for a given roof, which is a sound habit when a roof is old and the tile may not be a current one.

Read down the table and the pattern is plain. The flattest figures belong to large profiled tiles, and the plain concrete tile at the bottom, small and flat, needs the steepest roof of all.

Minimum pitch for Marley concrete tiles
Marley concrete tileMinimum pitch
Mendip 12.512.5 degrees
Mendip (smooth)15 degrees
Wessex15 degrees
Edgemere17.5 degrees
Modern and Duo (smooth)17.5 degrees
Double Roman (smooth)22.5 degrees
Ludlow Major (smooth), Ludlow Plus and Ashmore22.5 degrees
Anglia (smooth)25 degrees
Plain35 degrees

The names are product names, not places. Ludlow, for example, is a Marley range name and says nothing about a tile's origin or where it can be used. See what double roman tiles are for the best known profile in the table.

Lifespan, repair rate and the fit with older roofs

Published lifespans do not agree on concrete, so each source is named. Marley expects its roof tiles to last around 60 years; HomeBuilding gives plain concrete tiles 40 to 50. Neither is a promise, and a tile can outlast its fixings or the other way round. The concrete interlocking tiles guide sets out the family in more detail.

For repair work, Checkatrade's June 2026 guide puts concrete tile repairs at £90 to £120 per m², excluding VAT, when the patch is no more than 3 m². It is a rate per square metre and not a roof total.

Older houses raise a point the table cannot. If a concrete tile was put on a roof built for something else, such as stone or slate, the pitch may not match the tile's minimum at all, and the roof may already be failing along its laps. That shows up in the loft as daylight and staining. We photograph it and then say whether a repair is enough or the slope needs a covering that suits its angle.

The rules when a covering is changed

Pitch decides which tile can go on, and the rules decide what has to be done when one does. A heavier covering also affects the timbers underneath it. The two nations treat the work differently, as set out here, and the survey notes which applies to your address.

  • England: the Planning Portal's re-roofing test asks for under 25 per cent of the total building envelope and under 50 per cent of the roof to be affected, and a new covering that is 15 per cent or more heavier needs approval.
  • Wales: gov.wales says that in most situations re-roofing work needs Building Regulations approval, with slate to tiles given as an example of a different material.

Where a new concrete covering outweighs the old one, that is where the 15 per cent line bites. So a switch from a lighter covering to concrete is checked for structure first, whatever the pitch allows.

The pitched roofing page covers the wider choices. Our written price comes after a survey, and the survey records the pitch, the tile and the battens.

Related questions

My concrete tiles are on a very shallow roof. Is that a fault?

It may be fine. A few concrete tiles in Marley's table work from 12.5 to 15 degrees, though only the right tile on a correctly built roof. We identify the tile, measure the slope and look for staining, slipped courses and daylight in the loft. A roof that stays dry is read from its behaviour as well as its figures.

Can I choose any concrete tile for my roof pitch?

Only a tile whose published minimum is at or below your slope. Pick one just inside the limit and you have no margin. We prefer a tile with room to spare, and we give you the pitch reading and the data sheet figure side by side, so the choice is visible before any tile is ordered.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing