In brief
Yes, within limits. A new tile of the same material, profile and size as the old ones can sit alongside them, and it will look brighter until it weathers. Mixing clay with concrete, or one profile with another, is a different matter. The tiles differ in weight, in pitch and in how they lock together. We match each replacement to the tiles on your roof and photograph the result.
When old and new tiles sit well together
A roof may not be all one age. Tiles crack, slip and are replaced one at a time, so an older roof can carry a mix of ages. That works as long as the tiles are the same kind. A new plain clay tile in a plain clay roof, cut to the same size and set at the same gauge, takes its place without a fuss.
| Old roof | New tile | Result |
|---|---|---|
| Clay plain | Same clay plain | Fits, colour differs at first |
| Concrete | Same profile | Fits, if sizes match |
| Clay | Concrete | Weight and shape differ |
| One profile | Another profile | Laps and pitch differ |
The last two rows are where trouble starts. Colour is the visible difference. Weathering darkens clay and fades concrete, so a new tile reads lighter for a few seasons. On a back slope that goes unnoticed, but on a front slope a tile of the right size and the wrong shade can stand out from the lane. Our page on swapping a single cracked tile shows the usual repair.
Where mixing goes wrong
Tiles are made to be used with tiles of their own kind. Each has a profile, a lap, a thickness and a minimum pitch, and these work together across the slope. Marley's table gives each product its own minimum pitch: its Canterbury clay tile 40 degrees, its Ashdowne 35 and its Lincoln pantile 15, while its concrete tiles run from 12.5 degrees for the Mendip 12.5 up to 35 for the Plain. A tile of one type laid among another can leave a lap too short for the slope.
Weight is the other risk. Tiles of different materials do not weigh the same per square metre, and a roof structure is built for the covering it was designed to carry. A few concrete tiles among clay add little, but a whole slope of a heavier covering can change the load.
Where a close match cannot be found, we put the best-matching tiles on the front slope and keep the odd pieces for the back, where the join cannot be seen from the lane. We photograph both slopes so you can see the result.
Reclaimed tiles, stone and slate
Reclaimed tiles are the usual route to a close match on an old clay roof, because their weathering and size already agree with the roof. We check each for cracks and frost damage before it is laid. HomeBuilding rates reclaimed Welsh slate at 50 to 80 years, against 100+ for new Welsh slate, so a reclaimed covering has less life left than a new one.
Stone is the other local covering here. The Herefordshire building stone atlas ranks the St Maughans Formation first among roofing stones, with numerous permissions to work it in the Golden Valley area, and adds that Longtown's older cottages keep flagstone roofs. SPAB records that many such roofs have been altered, some to other stones and some to slate or imitation stone slate. It also says that any claim that stone is unavailable should be put to the quarries. No pitch figure for stone tiles is sourced, so each roof is judged on its own.
Mixing stone with slate or tile is a change of covering and is treated that way. Our page on clay plain tiles in Herefordshire shows the clay side of the county.
Weight, planning and cost across the border
The rules treat a few matching tiles and a new kind of covering differently, and the two countries word them in their own ways:
- In England, the Planning Portal expects Building Regulations approval once a new covering outweighs the old by 15 per cent or more, while Approved Document A speaks of more than 15%.
- In England, Class C of the 2015 GPDO covers re-covering, and it has no condition on matching.
- In Wales, gov.wales lists a switch from slate to tiles among the changes of material likely to need approval.
- In Wales, Class C.2(a) of the 1995 GPDO ties new materials to the look of the old, so far as practicable.
For repairs, Checkatrade (June 2026, excluding VAT) gives concrete tiles at £90 to £120, clay at £110 to £160 and natural slate at £150 to £220, each per m² and up to 3 m². Your price follows our survey as one written total. Listed status or a conservation area means the council should hear about it before the look of the roof alters. The pitched roofing hub lists related pages.
