Short answer
A gutter overflows when it cannot pass the water it receives. The causes are leaves, moss or a nest blocking the run or the outlet, a lost fall that leaves water standing, a downpipe blocked below, or a valley or steep slope pouring more water into one point than the gutter can carry. The spot where the spill happens tells you which.
Blockage at the outlet or the downpipe
The simplest cause is that something is in the way. Leaves, moss from the roof, grit from tiles and old nests all collect in the run and settle at the lowest point, which is the outlet. Once the outlet is covered, the gutter fills from the bottom up and spills over the front edge in the middle of a run.
A blocked downpipe has the same effect from below. The gutter itself is clear, but the water has nowhere to go, so the run backs up and overflows near the outlet. A choked drain at the foot of the pipe can be the cause, and our clearing a blocked downpipe page walks through the steps.
For a sense of scale, a survey of Trusted Traders by Which? in November 2025 gave £75 to £350 for clearing every gutter, ex VAT. That is a third-party guide, not our price. If a roof sheds a lot of moss, clearing once will not hold, and the cause is on the roof above.
Do not clear a gutter from a ladder resting on its edge. The brackets bend, and the fall goes with them. Gutter guards and leaf mesh keep out leaves, and they suit a run whose fall and brackets are already right.
Lost fall, sagging brackets and a dropped fascia
A gutter that is clear but still spills has probably lost its fall. Brett Martin advises 1mm of fall for every 600mm of run, which is a very slight slope, so a bracket that has dropped by a few millimetres can leave a stretch of the run holding water. In a downpour that stretch fills and spills over the front.
The causes sit behind the gutter, in the parts that hold it up:
- brackets that have pulled out of a soft fascia
- brackets set too far apart for the weight they carry
- a fascia board that has dropped, twisted or rotted
- a joint that has opened and let the run slump
Spilling at one corner of a run, with a dip you can see, points to a bracket or the board. A level laid along the gutter bottom shows the dip at once. Realigning the run puts the fall back. If the board is soft, the board comes first, and the signs of rotten fascias page lists what to look for before a ladder goes up.
Valleys, steep slopes and undersized runs
Some overflows are a matter of volume. Where two roof slopes meet at a valley, the water from both is gathered into one stream and delivered to the gutter at a single point. That corner takes far more flow than a stretch of plain eaves, and a gutter or outlet sized for plain eaves can be overwhelmed there.
Water also leaves a steep slope at speed. It can shoot over the front of a half-round gutter instead of dropping into it. A bigger profile, a second outlet nearer the valley, or a splash guard at the corner are the usual answers, and the survey picks between them. Each has a cost in appearance, so we show you where it would sit before it is ordered. Where the valley sits above a short length of gutter between two downpipes, the corner takes the full flow, so the outlet position matters as much as the gutter size.
If the overflow began after work to the roof, look at the eaves. A new bottom course set too far out can drop water in front of the gutter, and a missing tray can leave the underlay sagging, which sends the flow behind the gutter instead. Our eaves protection tray page explains that detail.
What overflow does to the building, and what we check
Water spilling over the front of a gutter runs down the wall, soaks the brickwork at the foot and can reach the foundations. Spilling behind the gutter wets the fascia and the rafter ends, which is how rot starts. Both cost more to mend than the gutter work that would have prevented them. Green staining on the wall, or a patch that stays dark long after the rain has stopped, shows where the flow has been going.
At the survey we run water through the gutter, photograph where it leaves, and check the fascia, brackets, outlet and downpipe in turn. What follows the survey is a written total price, and the guttering, soffits and fascias page sets out the wider roofline.
One caution on older houses: on a house built or refurbished before 2000, gutters and downpipes may be asbestos cement, so HSE advises assuming a risk until a material is identified. We do not break up or scrub a suspect run. A licensed firm handles any licensed work, and for waste, England excludes asbestos from its household consignment-note exemption, while NRW expects consignment notes from Welsh contractors moving domestic asbestos.
