01432 610152 Get a quote Call 01432 610152

Rotten fascias

How do I know my fascias are rotten?

Rot starts where you cannot see it, along the top edge behind the gutter, so the clues are on the face of the board and on the wall below.

Short answer

Look for paint that blisters or peels, a board that feels spongy under a thumb or a screwdriver tip, dark stains or green growth on the face, gaps where boards meet, and brackets that have loosened. A damp stain on the wall below, or a gutter hanging lower at one end, adds to the picture. Any of these on a timber fascia is worth a closer look before the next wet spell.

What shows from the garden

Stand back from the house on a dry day and look along the eaves. A fascia in good order is a straight line with an even coat of paint. Rot shows up as a change in that line, and the change is easier to spot from a distance than from a ladder.

The signs worth noting from the ground:

  • paint that bubbles, flakes or lets bare grey timber show through
  • a wavy or sagging lower edge on the board
  • dark patches, green growth or black speckling on the face
  • a gap at a corner or joint that was tight when the board went up
  • a gutter that dips between brackets or has pulled away from the board

A wall that is stained or damp below the gutter line can mean the board and the gutter are no longer working together. Our page on damp walls below the gutter follows that trail further. Photograph what you see in daylight, with the house number or a known landmark in the frame, so we can match the pictures to the survey later.

The screwdriver test

From a safe stance, push a thin blade or a screwdriver tip into the timber at a few points. Sound wood resists and leaves a small dent. Rotten wood gives way, crumbles, or comes away in a wet, stringy lump. The top edge and the ends of each board can hold water, so the blade goes in there first.

Wet rot and dry rot both soften timber, and either can spread into the rafter ends and the soffit behind the fascia. From the ground you cannot tell how far it has gone. On a survey we reach the eaves, probe the board and the rafter feet behind it, and photograph the result, so you see the same wood we do.

Do not lean a ladder against a board you suspect is rotten. The face may look firm while the board hangs from a few screws that have nothing to bite on, and a full gutter weighs a good deal. If a section already moves when you push it with a gloved hand from a stable stance, treat it as failing and leave the testing to us.

Plastic boards, painted boards and soffits that may hold asbestos

uPVC does not rot, but it can bow, split and go brittle. A retailer of uPVC boards, which has an interest in the figure, says they can typically perform reliably for 20 to 40 years. That figure comes from a seller, so read it as typical and not guaranteed. A plastic fascia can also hide a timber one, because capping goes straight over the old board. If a capped board is sagging, the timber under it may be the cause. Tap along it and listen for a hollow note where the wood has shrunk away behind the plastic.

The soffit underneath needs separate care. HSE's advice, for a house put up or refurbished before 2000, is to assume asbestos, and the locations it lists include pale soffit boards made of insulating board. Do not drill, cut or scrub them. Removing such board is usually a job for a licensed firm.

The waste follows separate rules in each country. England keeps asbestos out of its household consignment-note exemption, which covers hazardous waste "other than asbestos waste". NRW, the Welsh regulator, expects contractors who move domestic asbestos to raise consignment notes.

What to do once you think a fascia is going

Photograph the stains and the board from the ground and note which side of the house it is on. Keep a dated set from before and after a wet spell, because it shows whether a stain is spreading. That alone tells us what to bring. Then have the eaves looked at, because one soft board need not be the only one: the screws that hold the gutter are in the same wood, and the rafter ends behind it share the same damp air.

The choice is between mending a short length, replacing the boards, or capping the existing ones. Capping puts a plastic skin over timber, so it only suits boards that are sound underneath. Our capping or replacing fascias page sets that out, and our guttering, soffits and fascias page covers the wider roofline.

Nesting birds sometimes use gaps behind a failing board. A nest that is occupied or being built is protected by section 1 of the Wildlife and Countryside Act 1981: intentionally harming it is an offence, so we look before opening the eaves. If bats turn up, the licence comes from Natural England in England and from Natural Resources Wales in Wales, and the job waits.

Related questions

Can I paint over a fascia that feels slightly soft?

Paint will not stop rot that has already started. Soft timber has lost its strength, so brackets pulled into it will not hold for long. A soft patch the size of a thumbnail may be repairable; a board that gives under a screwdriver along its length is better replaced.

Is the damp patch below my gutter caused by the fascia?

It can be, though a leaking joint, a blocked downpipe or an overflowing gutter are other possible causes. A fascia that has dropped changes the fall, so water spills at the lowest point. A survey sorts out which of these is at work on your house.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing