01432 610152 Get a quote Call 01432 610152

Box gutter leaks

Why is my box gutter leaking?

A box gutter has no lip to spill over, so when it fails or fills, the water goes indoors. The cause lies in the lining, the outlet or the fall.

In brief

A box gutter is a lined trough built between two roofs or behind a parapet wall. It has no outer lip, so any failure sends water inward, into the ceiling below. Three faults account for a leak: a lining that has split, lifted or perished; an outlet that is blocked, with no overflow to relieve it; and a floor that has sagged and holds a pool. A fourth, the upstand where the lining meets a wall, can fail on its own.

Why the water comes indoors

A gutter hung on the outside of a wall spills over its lip when it is full. A box gutter is built the other way round. Its sides rise against the roof slopes or the wall, and the trough sits inside the line of the building. When it cannot empty, the level rises until it finds the lowest point of the edge, and that point can be above a ceiling.

The parts have names that help in describing a fault. The sole is the floor of the trough. The outlet is the opening where the water leaves, for example into a hopper head and downpipe. An overflow is a second opening set a little higher, which relieves a blocked outlet by sending the water out through the wall. The upstand is the lining turned up the face of a wall, with a flashing over its top edge.

Everything on a large roof drains into this one channel, so a modest blockage turns into a flood quickly. Our guide to valley and box gutters on commercial roofs covers the types and the linings.

Fall: why a pool in the sole matters

A gutter that does not drain leaves a pool, and a pool does the damage. It loads the boards, it ages the lining and it gives a small flaw hours of water to work with. The slope of the floor is therefore the first thing worth measuring.

Falls, as published
SourceWhat it saysApplies to
NFRC on BS 6229:2025A minimum finished fall of 1:80, which includes internal guttersRoofs covered by flexible membranes
IKODesign for 1:40 to reach 1:80Single-ply flat roofs
Brett Martin1mm for every 600mmOrdinary rainwater gutters

BS 6229:2025 is a standard for membranes, and it does not cover lead. A lead-lined gutter takes its guidance from the lead codes, which Royston Lead lists by use. The 2018 edition of BS 6229 was withdrawn on 16 December 2025.

A floor that holds water after a dry spell has either lost its slope, because the boards below have sagged, or never had enough. A new lining over that floor pools again, so the slope has to be corrected before anything else.

Tracing the entry point from inside and out

A stain on a ceiling shows where the water landed, not where it entered. Water runs along timber and lining before it drops. We start in the unit and read the clues:

  • a ring or bubble on the ceiling under the line of the trough
  • damp plaster at the head of a wall on the far side of the gutter
  • salt bloom, a white crust, on brickwork beneath a parapet
  • soft, dark timber under the sole, where the void can be reached

The timing says a lot. A drip that begins in a storm and stops soon after suggests a blocked outlet. A drip that carries on for a day after rain suggests a pool draining slowly through a small flaw.

Then we go up from a platform or tower and photograph each outlet, each seam and each upstand, with the debris still in place. Leaves, silt and old roofing offcuts show how long the outlet has been choked. You see the photographs, and the repair is chosen from what they show. Our answer on why a metal roof drips inside helps separate a gutter leak from condensation.

Patch, reline or rebuild, and the approvals

The remedy follows the fault. A lifted seam, a split corner or a cleared outlet is a local repair. Perished lining along its whole run, over sound boards and a true slope, is relined. A sagged floor or rotten boards need rebuilding before any new lining is laid. Where the rest is sound, a patch is the sensible buy, and the survey says when it is not.

Access is part of the work. Under section 169 of the Highways Act 1980, a scaffold on the pavement needs a licence, and we arrange the licence with our scaffolder. The written quote is one total and carries the scaffold.

Approvals depend on the country, once the job is large enough to count as re-roofing:

  • In England, the Planning Portal tests houses against "Less than 25 per cent of the total 'building envelope'" and "Less than 50 per cent of the roof".
  • In Wales, the Welsh Government says "In most situations, this work will need Building Regulations approval."

Ask building control which test your building falls under. The commercial roofing page explains how a survey leads to the quote.

Related questions

Can a box gutter be mended while it is still raining?

A temporary cover or a cleared outlet will slow the water, but a lasting repair needs a dry lining and dry boards, because wet lead, membrane or timber will not bond or seal. In a storm the first jobs are to make safe, clear the outlet from a safe position and move stock away from the stain.

Is replacing the whole gutter cheaper than patching it?

Not automatically. A patch is the better buy when the lining and boards are sound and the fault is local. New work is the right answer when the floor has sagged or the lining has gone along its whole run. The survey photographs both, and one written total follows from what is found.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing