A chimney stack stands higher than the rest of the roof and is harder to reach, which is why chimney repair cost in Hereford swings so much between one house and the next. Two stacks with the same tired mortar can need quite different jobs once the height, how the stack is reached and the condition of the lead round the base are counted in.
This post sets out what moves the price of chimney work, which published cost ranges exist for the jobs that have one, and why some jobs are priced only after a survey. The figures come from national cost guides, each named and dated, and none of them is a price from us. We start every survey on the skyline, and the stack carries a good share of the skyline's detail.
Later sections cover lead flashing, taking a chimney breast or a whole stack down, and the rules that differ between England and Wales. The repair work itself is set out on our chimney repairs page.
What moves the price of chimney work
Before any figure, the stack itself sets the scale of the job. Look at the chimney from the garden and these are the questions a surveyor is already asking.
- Reach: a stack beside a low rear slope can be worked from a roof ladder and crawling boards, while one on a tall gable end needs scaffold, and scaffold adds to the total.
- Size: a single flue with one pot is a smaller job than a wide stack carrying six pots and sitting on a party wall.
- Material: brick, rendered brick and stone behave differently. In the county's stone atlas, the chimney stacks on timber-framed houses are "commonly of local sandstone", and a sandstone stack is pointed and mended differently from a brick one.
- Fault: a cracked flaunching (the mortar collar that beds the pots) is a smaller repair than loose masonry or a stack leaning away from the roof.
- Lead: new flashings, plus a back gutter (a lead channel set against the uphill face of the stack), cost more than dressing down a lifted edge.
- Height: every extra course of brick or stone is more to rebuild, more to reach and more to carry down.
- Use: a stack with a live flue is finished at the top in a different way from one that is capped and unused.
Putting scaffold on or across the footway or carriageway means a licence under the Highways Act 1980 s169, and we arrange the licence with our scaffolder. Herefordshire Council charges £167 per licence, which runs for a maximum of 1 month, while Monmouthshire County Council sets an administration fee of £108. A terraced street with no front garden is where this matters most, because the scaffold has nowhere else to stand. Those are council fees for the licence alone, each with its own unit, and the written quote has the scaffold built in.
Repointing, flaunching and pots: priced after a survey
Repointing is a job we cannot price from a photograph. That price is set after a survey, once someone has seen how deep the mortar has gone and how sound the brick or stone behind it is. A joint that looks grey and weathered from the garden may be solid, and a joint that looks tidy may sound hollow when it is probed. Brick stacks, stone stacks and rendered stacks are each repointed with a different mortar and a different tool, so even the first visit has to identify what the stack is made of.
The same goes for the other work at the top of a stack. Flaunching is the sloping mortar collar at the head of the stack that holds the pots and sheds rain. If it cracks, rain gets into the flue and the masonry below, and the repair may be a small patch or a full re-bed of every pot. A leaning pot or a broken cowl changes the job again. None of these can be judged from the ground with any accuracy.
What the survey looks at, in the order we look:
- the mortar joints, probed for depth rather than judged by colour
- the flaunching and the pots
- the brick or stone faces, for frost damage and loose pieces
- the flashings where the stack meets the slope
- the roof timbers beside the stack, seen from the loft
Each point gets a photograph from your own roof, shown to you ahead of any agreement, so the quote matches what is up there. Where the survey finds sound mortar and a tired flashing, the quote says so, and the repair is the flashing alone. Our guide to repointing a chimney stack goes into the repair itself, joint by joint.
Lead flashing: the published ranges
Lead flashing is the strip of lead that seals the gap where a stack rises through the roof slope. It is one of two parts of chimney work with published national figures; removal, further down, is the other. MyJobQuote, in a page dated 22 September 2026, puts a patch repair to the lead at around £200 and a full replacement at an average of around £570. For full leadwork it gives £350 to £920, "depending largely on whether scaffolding is required".
| Job | Figure |
|---|---|
| Lead flashing patch repair | Around £200 |
| Full replacement of the flashing | Around £570 |
| Full leadwork | £350 to £920 |
The line about scaffolding is the useful part of the MyJobQuote entry. The same lead job costs more where scaffold is the only way to reach the stack, which fits what a survey finds on a tall gable end. On life expectancy, MyJobQuote says correctly fitted flashing can last over 80 years. That is a hedged claim about good installation, not a promise about any one stack. Our guide to chimney flashing leaks shows how the joint fails.
Checkatrade lists lead flashing repairs at £50 to £70 per metre in its June 2026 rates, which exclude VAT. That is a rate per metre and it stays one. A stack has no standard number of metres, so a single rate will not give you the total for your house.
Taking a breast or a whole stack down
Removal is the other chimney job with published figures. MyJobQuote, in a page dated 3 November 2026, puts removal of a chimney breast at around £2,500 on average, within a range of £1,200 to £3,500. For taking away the whole stack together with the breast it gives around £3,000 to £3,500. The breast is the indoor part, taking the flues up past the rooms; the stack is the portion above the roof.
The price is only half of it, because the work has rules, and the rules change with the nation the house stands in:
- In England, which covers Herefordshire, the Planning Portal says: "Building regulations approval will always apply when removing chimney breasts as they are part of the building's structure."
- In Wales, we ask the council's building control service about a removal before we price it, because the Welsh rules are not the English ones.
- In Wales, a chimney taken off a house on article 1(5) land (in a conservation area or a National Park, for example) falls outside permitted development under the 1995 Order, Class C.1(c)(vii), so the planning question comes first there.
- In either country, cutting away a shared chimney breast is work the Party Wall etc. Act 1996 covers, and the building owner is the one who sends the notice.
Support for the floors and the roof above, the notice to a neighbour where one is needed, and the weatherproof finish where the stack used to be all sit behind one quoted total.
Our post on taking a chimney down in Hereford walks through the steps.
Reading a written price for chimney work
When the survey is done, you should receive one written total for the job, covering everything needed to finish it and leave the site tidy. For a chimney, check that the paperwork answers these questions in plain words:
- Which faults are being dealt with: pointing, flaunching, pots, flashings, or a rebuild above the roofline?
- Is scaffold part of the total, and does the quote say whether VAT is?
- Is the lead new, and which code of lead is it? Royston Lead's table marks Code 3 as recommended for lead soakers only, which is a different job from a flashing.
- Are the old masonry and the waste taken away?
- Will you get photographs of the stack before and after?
- Does it say what happens if a hidden fault shows up once the old pointing is raked out?
A figure from a cost guide is a national average across the whole of the UK, and it is useful only as a check on whether a quote is in the right area. HomeBuilding notes that labour rates are higher in London and the South East, which shows how far a national average can sit from a Herefordshire job. None of it replaces someone looking at your stack from the roof, with a camera, and writing down what is there.
A contract signed at your own house after we have surveyed is covered by a 14-day cancellation period, and you can ask us in writing to start sooner. Our short answers on the cost of removing a chimney breast and a whole stack cover the removal figures in fewer words.
Older stacks, listed houses and the consent question
On an old house the stack can be part of what makes it special, and the work can need consent as well as a price. In England, the Planning (Listed Buildings and Conservation Areas) Act 1990 s7 makes works to a listed house unlawful unless they are authorised, where they would alter what makes the house special enough to be listed. In Wales the same ground is covered by the Historic Environment (Wales) Act 2023, sections 88 and 89, in force since 4 November 2024. A listed house keeps its permitted development classes, but needs consent on top of them.
For a listed house, ask the council before anything is raked out or rebuilt, and keep the stack's original materials in view when the quote is written. Herefordshire Council says there are 64 conservation areas in the county, and a stack in one of them is a question for the planning team before its appearance changes. Whether an Article 4 direction applies to your street is also something to check with your council, because we cannot tell you what a direction covers without seeing the direction.
The same care applies to the timber-framed houses of the county, whose big outside stacks are part of their look. Whatever the age of the house, the survey notes how the stack was built before it suggests how to mend it. A stack that has been rebuilt once already, in brick on top of old stone, is recorded as it stands, with a photograph of the join, because the repair has to suit both halves.
