Callout 1 of 3
Capping tiles along a Yarkhill ridge, bedded and fixed
We reach a Yarkhill ridge by ladder or from the scaffold, and the first job is to press down on each capping tile. Capping is the row of curved or angled tiles that finishes the top of a roof. Beneath it sits a bed of mortar or, on newer work, a dry-fix set of clips and screws. Any tile that shifts under the palm has lost its bed, which answers the question we climbed up to ask.
The Royal Commission's 1932 Herefordshire inventory covers Yarkhill parish. Its entry for the monuments numbered 4 to 15 calls them, unless stated otherwise, buildings that "are of the 17th century and of two storeys, timber-framed and with tile or slate-covered roofs". A ridge over one of those houses could be capped in clay, finished in slate or fitted with something newer, and each wants its own fixing.
Mortar joints get read next. Where one has crumbled, rain runs into the top course and wets the battens, which are the slim timber laths the covering hangs from. Hips, the angled outer corners between two slopes, receive the same hand test, since two roof planes shed onto a single line of mortar there. Inside the loft we look up along the ridge board for chinks of daylight and for tide marks on the timber.
Marley, the tile maker, states that "Installing to BS 5534 isn't required by law", yet the 2015 amendments, it says, made clear that mortar "could no longer be relied upon as the only means of securing the roof covering". BS 5534:2014+A2:2018 sets out how slate and tile roofs are fixed, and BS 8612 covers dry-fix systems. Bedding stays in use. On an older house we can keep the bedded look and still put a stainless screw or clip through every capping tile, so a bed that fails in ten years leaves the tile in place.
Re-bedding a stretch of capping and renewing a few cracked tiles is a smaller job than stripping a slope, and the report treats it as the modest repair it is. Where the covering below the ridge has worn out, the photographs show that as well, with the position given from the nearest gable so the fault can be found again. Our roof repairs page explains how a smaller job is set out.
Checked along a Yarkhill ridge
- Loose capping, tested by hand along the whole run
- Mortar joints that have opened or crumbled
- A fixing driven through every capping tile
- Hip junctions and the end tile at each gable
- Daylight or staining under the ridge board
A ridge that needs re-bedding is small work, and the report says so.















