Callout 1 of 3
Gutters, fascias and the eaves line
At the bottom of a slope, the eaves, rainwater passes from the covering into the gutter, which carries it to a downpipe. Brett Martin advises a fall of "1mm for every 600mm", so a 6 metre run drops just 10mm along its length. That is too slight to judge by eye, which is why the survey pours water into the gutter and watches where it pools. A pool points to a sagging bracket, a joint that has opened or an outlet silted up with leaf mould, and each one is photographed for the report.
A fascia is the board fixed across the rafter ends, with the gutter screwed to it, and a soffit closes the gap under the overhang. For buildings built or refurbished before 2000, HSE's line is to "assume that there is asbestos in it", and asbestos insulating board (AIB), sometimes used for white soffits, is one place it can sit. AIB is usually licensed work to lift, so a licensed firm does the lifting. Asbestos cement is a different material: HSE places careful removal that avoids breaking it up in the non-licensed category, and says such roofs are "always fragile". Nobody walks on one, and waste from the job leaves in a skip that locks, not an open one.
Where a board has rotted behind a gutter, the rafter ends beneath it are checked, since decay travels in from the edge. If they are sound, new boards go on, and a vented soffit lets air into the roof space. Plastic, timber and aluminium boards each have their place, and the choice follows the house: a painted timber fascia can suit an older cottage, and a capped board can suit a house that has been re-fascia'd before.
Slipped tiles on the lowest course are noted on the same visit, since they sit right above the gutter. Gutter profile matters less than gutter fall: a half-round, square or ogee section works if the run is true and the outlets are clear, so the profile already on the house is matched. A bracket that has sagged is re-set at the right spacing, and a joint that has opened is re-sealed or the section replaced. The guttering, soffits and fascias page sets out the full range of boards and gutter profiles, and every board we replace is photographed before and after.
The eaves line on a Rock house
- Gutter run
- Fall tested with water, joints and brackets checked
- Fascia
- Board that carries the gutter, probed for rot
- Soffit
- Board under the overhang, vented where it is renewed
- Rafter ends
- Looked at where a board has gone soft
- Downpipe
- Cleared, and its joints watched under flow
Level to the eye can still be wrong for water, so the gutter is tested with water.















