Callout 1 of 3
Ridges and hips on tile, stone and slate roofs
The highest line on any house is where weather does its first damage, so the survey climbs to the ridge before anything else. In Orleton parish the Royal Commission's 1934 Herefordshire inventory described the monuments it listed as dating to the 1600s, two floors high and timber-framed, giving their roofs as "tile, stone or slate-covered". Three different coverings are named there, and each wants its own ridge: clay or concrete capping on tile, a bedded stone or a lead roll on stone, and a bedded capping or a lead roll on slate.
Capping stays on only while its fixings hold. A capping tile is traditionally bedded in mortar, and mortar cracks as the roof moves through winter and summer. Marley, the tile maker, puts the rule this way: "Installing to BS 5534 isn't required by law", yet the 2015 amendments made it clear that mortar "could no longer be relied upon as the only means of securing the roof covering". Mortar is not banned. Each capping tile also gets a mechanical fixing, and where a roof has been dry-fixed, BS 8612 is the specification that governs the clips and screws.
Hips get the same attention. On a hipped roof the hip runs down the outside corner where two slopes meet, and it is bedded and capped like a ridge, with an end tile at the foot. Lifted hip caps can show as a thin dark line down the plaster inside a bedroom. We lift the loft hatch and trace any stain upward, so that the repair goes to the true source and not the place where the drip lands.
Pitch decides which covering a roof can carry. Marley's minimum pitches run from 12.5 degrees for its Mendip 12.5 concrete tile up to 40 degrees for its Canterbury clay tile, and the data sheet of the tile in question always has the last word. The survey measures the pitch before anyone talks about changing a covering.
Where the covering beneath is sound, a rebedded ridge counts as a repair and nothing larger. The Planning Portal lists a new covering that "increases the weight of the roof covering by 15 per cent or more" as a trigger for Building Regulations approval, which is why a change of material is checked for load first. Our roof repairs page lists the smaller jobs a survey can lead to.
Checked along an Orleton ridge
- Capping that moves under a gloved hand
- Mortar joints that have crazed or dropped
- Clips or screws fixing each capping tile
- End tiles at the foot of each hip
- Stains in the loft below the line
Rebed the ridge on a sound roof and you have bought years, without a new roof.















