Callout 1 of 3
Where Mathon's timber frames meet their coverings
Callout one is the timber frame, where a covering finishes against old oak. In 1932 the Royal Commission took the Mathon monuments numbered 5 to 28 together and, unless otherwise stated, called them buildings that "are of the 17th century and of two storeys, timber-framed and with tile or slate-covered roofs". For the parish church it says "the roofs are tiled." Those entries record what stood in 1932. A house re-covered since may have changed, so we identify the covering on every roof before anything is suggested.
Timber framing shifts through the year, and the covering has to allow for it. We look first at the verge on each gable, where the roof edge meets the frame, then at the wall plate. That is the beam laid on top of the wall, which the rafters bear upon. Inside the loft we study the rafter feet and the underside of the covering for daylight, because damp in old oak will show there before a bedroom ceiling is marked.
When a covering has to be renewed, pitch decides what can be fitted. Marley publishes minimum pitches by product: its plain concrete tile needs 35 degrees, and its clay Canterbury tile 40, while the Lincoln pantile can go down to 15. Those are product names rather than local styles, and the maker's data sheet has the last word. Cupa's slate guidance gives 20 degrees as the lowest natural-slate pitch, but only for moderate exposure, a 500mm slate and a 115mm overlap. We measure the pitch on site before a material is named.
The repair is matched to the frame. Tight, bedded verges, soakers (small folded lead pieces) where a slope butts against a wall, and a clean line along the wall plate all keep weather off old timber. The pitched roofing page lists the coverings we fit and the way they are fixed.
The Planning Portal sets two thresholds for a re-cover at a Mathon address, both for England: under 25 per cent of the building envelope and under 50 per cent of the roof. Staying beneath both, the Portal's answer is that you can normally proceed without an application. A heavier covering is a different test, because approval is needed once the weight rises by 15 per cent or more.
Lifespans differ by covering and by source. HomeBuilding puts clay tiles at 60 to 80 years and plain concrete tiles at 40 to 50, while Marley expects concrete tiles to last around 60 years. Those are typical ranges, so we read the condition of each tile and not its age.
Checked where frame meets covering
- Verge bedding at each timber gable
- The line along the wall plate
- Soakers where a slope meets a wall
- Rafter feet seen from the loft
- Daylight or staining under the covering
Old oak gets read from inside the loft and from the ladder both.















