Callout 1 of 3
Where tiles meet a brick modillion cornice
The Victoria County History, writing in 1924, describes Court Farm, near the rectory on the Worcester road, as a "three-storied red brick building" that "has a tiled roof and a brick modillion cornice". That is one farmhouse, not the village. A cornice is the projecting course at the top of a wall, and modillions are the small brackets beneath it. When the cornice is brick, the foot of the roof, any gutter and the masonry all meet in one tight detail, and a leak there can run behind the brickwork for a long way before it shows anywhere inside.
So the survey takes the roof edge slowly. We look at the pointing of the cornice, at the tiles that finish above it, and at the flashing or gutter that bridges the two. Inside, a stain on the ceiling directly below the cornice line is photographed and compared with the outside. A tiled roof is built from battens, the timber laths carrying the tiles, laid over underlay, the sheet beneath them, and both have to stop neatly at the edge, so we lift a course to look when the signs point there.
Ventilation matters at the same place. Where HR underlay (high resistance, so not vapour permeable) sits under a cold roof, Marley asks for "25mm along the length of the eaves for pitches of 15° or less; 10mm along the length of the eaves for pitches of more than 15°". A cornice that has been closed up or painted over, or insulation pushed hard against the edge, can undo that, so we check the gap while we are there. If the cornice hides a gutter, the first sign of a blocked outlet is a damp patch on the brickwork below it, so the outlets are checked too, and a hand-held camera shows you the channel behind the brick.
Where lead dresses a brick course, Royston Lead's table lists Codes 4, 5 and 6 for flashings, and the code follows the position. MyJobQuote says correctly installed lead flashing "can last for over 80 years", so sound lead stays. Our roof repairs page covers edge repairs, and lead roofing covers new flashings and gutters in sheet lead.
The roof edge at a brick cornice
- Cornice pointing
- Joints raked and checked for gaps
- Edge tiles
- Lifted where signs point to a leak
- Underlay and battens
- Followed to the edge and photographed
- Ventilation gap
- Measured against the eaves guidance
- Lead or gutter
- Joint between roof and masonry tested
Where brick meets tile, a leak can travel a long way before it shows.















