01432 610152 Get a quote Call 01432 610152

Roofers in Lyonshall

Tile, stone and slate roofs near a Grade II* church and a castle ruin.

The survey works downwards from the ridge, photographing each fault on the way and closing with one written total.

Get a free quoteCall 01432 610152

Lyonshall's tile, stone and slate coverings

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Three coverings recordedIn 1934 the inventory recorded tile, stone and slate roofs on 17th-century timber-framed monuments.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Valleys between slopesLead-lined valleys carry run-off from two slopes and need checking at both edges.
  • Newer homes with grey concrete tile roofs along a curving estate road
    A listed church and castleLyonshall's church carries a Grade II* listing, and the castle ruins are Grade II.

A map of Lyonshall

Lyonshall on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Lyonshall roofs, from ridge to listed wall

On a Lyonshall roof: ridge, valley and listed wall

The survey follows the rain: first along the ridge, where three kinds of covering are capped, then down into the lead valley between two slopes, and last to the listed buildings that decide who has to be asked.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge capping; 2 Lead valley; 3 Listed buildings.

Fig. 1 Lyonshall's roof cut open, with its ridge, valley and wall marked one to three.

Callout 1 of 3

Capping the ridge over tile, stone and slate

Callout one sits at the crest of the roof, the ridge, where its two main slopes join. For Lyonshall the Royal Commission's inventory of 1934 treats the parish's monuments 3 to 19 as one group: unless it says otherwise they "are of the 17th century and of two storeys, timber-framed and with tile, stone or slate-covered roofs". Three coverings are named, and each is capped in its own way. Clay tiles take ridge tiles, while stone and slate take cappings cut or bought to match them. A ridge that suited the covering in 1934 may not suit what is on the roof today, so we read the ridge against the slope beneath it.

Ridge pieces are laid on mortar or anchored dry by clips and screws. Marley says that installing to BS 5534 "isn't required by law", and notes that since the 2015 amendments mortar cannot stand as the sole fixing for a roof covering. Dry-fix work follows BS 8612. Each capping piece on a Lyonshall ridge is pressed in turn, because a piece that rocks has lost its bedding. We look for open joints where a hip arrives, a hip being the outward corner where two slopes meet, and at both gable ends. Mortar keeps its place on an older house, with each piece held by a fixing as well. At each gable end the last piece of capping meets the verge, the edge of the covering over the gable, so the two are examined together and the verge is checked for the same loose bedding.

How long a covering lasts depends on what it is. Marley reports that the BRE set a minimum of 60 years for clay roof tiles, and HomeBuilding gives clay tiles "60-80 years". For concrete tiles Marley says "around 60 years" while HomeBuilding says "40-50 years", and we give both because the sources differ. These are typical figures, not promises. Where a Lyonshall roof carries three coverings, the ridge may be the one part that has been redone, so the report notes the material of each length of capping and the way it is held.

A ridge that has come loose, with sound slopes below it, is repair work, and it is priced as repair work. If the survey shows the covering beneath has worn out, the report says so plainly and shows the evidence. Our pitched roofing page explains what happens when a whole slope has to be renewed.

What the ridge survey records

  • Capping pieces that rock under a hand
  • Open joints at the hips and gable ends
  • A fixing in every piece, not mortar alone
  • The covering beneath the capping
  • What each length of ridge is made of
Fig. 2 The ridge, drawn close

Callout 2 of 3

Lead valleys and the slopes that drain into them

Callout two drops into the valley, an inside angle formed by two joining slopes, and the run-off from both is delivered into a single channel. Lyonshall valleys may carry a lead lining, the covering on each side trimmed back to meet it. Royston Lead's table lists Code 4 through to Code 8 for pitched valley gutters, and leaves Code 3 for soakers alone. The code is matched to the channel and to the pitch it sits in. Each valley is cut and folded on site, because no two roofs meet at quite the same angle.

The edges are where a valley shows its age. Lead can split along a fold after years of movement, and the cut edges of the tiles or slates beside it can lift. Silt and moss gather in the channel and slow the run-off, and a channel that cannot empty quickly sends rain over the lead's edge into the slopes either side. The lead itself is checked along both sides for lifted tile cuts, and at the foot of the valley, where the water leaves the roof. We clear a valley by hand, then photograph the lead along its whole length, so that you can see every split. A length that has failed is replaced and the covering is re-cut to it. Sealant smeared along a split is not a repair.

Where the valley serves slate slopes, pitch matters. At the foot of a valley that meets a wall or a stack, soakers finish the junction, each a little bent sheet of lead tucked beneath a course, and Code 3 is the sheet Royston Lead recommends for soakers only. Cupa, the slate supplier, says BS 5534:2014+A2:2018 sets a floor of 20 degrees for natural slate, and only for moderate exposure, with a 500mm slate and a 115mm overlap. It adds that slate hooks should be avoided below 25 degrees. Before a slate is chosen for a repair we measure the pitch and write the figure down, so anyone can check the choice later.

On the life of lead work, MyJobQuote says correctly installed lead flashing "can last for over 80 years", which is a hedge and not a promise. A valley in good order is left as it is. Our lead roofing page covers sheet lead, from valleys to flashings and soakers.

A lead valley between two slopes

SoundLead lying flat, clear channel, tile edges tight to it
Needs workSplit at a fold, lifted tile edge, silt in the channel

Callout 3 of 3

The church, the Weymouth Arms and the castle ruins

Callout three is the wall, and in Lyonshall it belongs to listed buildings. List entry 1349918 is St Michael and All Angels, Grade II*, first listed 16 October 1967. The Old Weymouth Arms and the Wharf carries a Grade II listing (list entry 1166650, first listed 19 August 1953), and so do the ruins of Lyonshall Castle (list entry 1301287, first listed 16 October 1967). Under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990, anything that touches a listed building's special character needs listed building consent. A listed house keeps the permitted development it had, with that consent required alongside.

A grade says nothing about who looks after a church. The list entry records the building, and the route for roof work turns on the body that governs it and on whether worship continues there. Before any plan is made, we write to whoever governs the church. While the building is used for worship it may stand outside council consent, but a closed church does not. Either way the roof is photographed before and after, and the file stays with the building, so the next owner can see what was done and when.

Look up your street in Herefordshire Council's own conservation area list, since the county has 64 conservation areas, and ask the council whether an Article 4 direction applies to your address. A roof window or a dormer has conditions of its own, which our planning guide for roof windows sets out. Building control for a Lyonshall address is Herefordshire Council Building Control, on 01432 261938, with a registered building control approver as the alternative.

The listed and heritage roofing page explains the steps for a protected roof. Lyonshall is 16.8 road miles north-west of Hereford, about 27 minutes by road, and a survey visit is arranged from there. Where a house stands beside a listed building, we look at the shared boundary wall and gutter first, since that is where one owner's work reaches the next.

Repairing a listed roof

Does a like-for-like repair on a listed roof need consent?

Listed building consent is required for work affecting the character of the building. Whether a repair in like material does so is for Herefordshire Council to say, so we ask first, send pictures of the covering as it is, and wait for the reply before a single Lyonshall slate or tile is lifted.

Lyonshall roofs: ridges, valleys and listings

Which ridge capping suits a Lyonshall roof of tile, stone or slate?

The capping has to suit the covering beneath it. Clay roofs take ridge tiles, and stone or slate roofs take cappings cut or bought to match. Whichever is used, each piece is clipped or screwed down as well as bedded, because mortar alone no longer counts as the only way to secure a covering. The survey records what each length of ridge is made of, and if the slopes below carry a mixture of coverings, the report lists the mix slope by slope so that nothing is assumed.

How is a leaking lead valley on a Lyonshall house repaired?

The photographs show where the lead has split, and that length is replaced in a code chosen from Royston Lead's table for the span and pitch. Tiles or slates along the edges are lifted, re-cut and laid back to it. Silt is cleared by hand, since Marley advises against jet washing, and sealant is never used as a stand-in for new lead.

Which route covers roof work at Lyonshall's Grade II* church?

The church is list entry 1349918. Its grade does not say which body governs it, so we write to that body before any work. Where services continue, the ecclesiastical exemption may take a church outside council consent, while one that has closed needs listed building consent from Herefordshire Council. The answer decides who is approached first, and we keep it with the photographs for the file.

What does a Grade II listing, like the Old Weymouth Arms and the Wharf, mean for roof work?

It brings section 7 of the 1990 Act into play. Any work touching the special character of the building needs listed building consent from Herefordshire Council, alongside any permitted development a house keeps. The council hears from us before materials are bought, with pictures of the existing roof and a description of what is proposed for it. If the council wants a sample of the new slate or tile, we supply one and wait for the response before ordering the full quantity.

When does a Lyonshall re-roof need Building Regulations approval?

Two limits decide it in England, and both come from the Planning Portal: under 25 per cent of the building envelope and under 50 per cent of the roof. Beyond them, or with any change to insulation, Herefordshire Council Building Control (01432 261938) or a registered building control approver is asked first. Approval is also needed for a covering 15 per cent or more heavier.

What licence does scaffold on a Lyonshall road need?

A highway licence under section 169 of the Highways Act 1980, and we arrange the licence with our scaffolder. Herefordshire Council's licence is £167 for a maximum of one month, £123 for every month after, and the council asks for at least 10 days' notice, which governs when the scaffold can go up. If a Lyonshall house is on the main road, the licence paperwork is lodged before the scaffold is ordered. Scaffold cost is folded into the written total, which you receive after the survey.

Ask for a ridge-and-valley survey in Lyonshall

Send a photograph of the crest or the valley, and we will arrange a visit from Hereford, 16.8 road miles away.

10-year workmanship guarantee, in writing