01432 610152 Get a quote Call 01432 610152

Roofers in Culmington

Roof window, loft and roof repairs in Culmington, 29.1 road miles north of central Hereford.

Allow 42 minutes on the road. Surveys start in the loft and finish on the ridge, with photographs and one written total.

Get a free quoteCall 01432 610152

Tudor Lodge, Culmington House and All Saints

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Tudor Lodge, Grade IIListed in 1974, so a new roof window raises a consent question.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Culmington House, Grade IIListed in 1996, so changes to how the roof looks go to the council.
  • Newer homes with grey concrete tile roofs along a curving estate road
    All Saints church, Grade II*Listed in 1954; its faculty rules apply while the Church of England uses it.

The way to Culmington

Culmington on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Culmington roofs, from loft hatch to church wall

Culmington surveyed: windows and escape routes, insulation under the slope, and the listed walls

The read goes up through the loft: roof windows and the escape route a conversion needs, the insulation under the slope, and then the listed houses and church where consent comes first.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Loft windows; 2 Slope insulation; 3 Listed walls.

Fig. 1 A house in section, with loft window, insulated slope and wall head marked.

Callout 1 of 3

Roof windows and a loft conversion's escape route

Start at the loft hatch. Before a roof window is priced we look at what the room under the slope could become: the headroom, the strength of the floor, the stair that will serve it, and the rafters that would be trimmed round the opening. A roof window is glazing set flush into the slope. A dormer is a box built out from it, with walls and a roof of its own, and it is a far bigger job. Alterations to the roof in England include a roof window, and the conditions that go with it are laid out in our planning guide for roof windows. A conservation area, such as the one Shropshire Council records at Culmington, weighs on dormers, and the guide lists the conditions on a roof window.

The glazing carries an energy figure of its own. In AD L 2021 Table 4.2 the figure for a roof window is 1.4, or WER Band B. A rooflight is a different product with a different figure, 2.2. For the existing roof round a loft conversion, Table 4.3 gives 0.35 as the threshold and 0.16 as the improved figure. From 24 March 2027 AD L 2026 renumbers these as Tables 3.2 and 3.3.

A conversion also has to let people out. Where a storey sits more than 4.5 m above the ground, AD B paragraph 2.5 offers two choices: a stairway protected by fire-resisting construction, or an upper storey divided from the rest of the house, with a separate exit of its own. Paragraph 2.23 offers sprinklers in open-plan layouts as another route. An escape window under paragraph 2.10 needs an openable area of at least 0.33m2, no smaller than 450mm by 450mm, with its bottom edge no higher than 1100mm above the floor, and it serves storeys within 4.5 m of the ground.

A conversion goes through building control as a whole, not window by window: structure, stair, fire safety and insulation are all looked at, either by the council's service or by a registered building control approver. The existing roof is examined first. Rafters, underlay and covering are checked before a window is cut into them, because a window set into a worn slope only moves the problem. Our skylights page covers fitting, flashing kits and trim.

Figures behind a Culmington loft window

Roof window
AD L 2021 Table 4.2: 1.4 or WER Band B
Rooflight
AD L 2021 Table 4.2: 2.2
Existing roof
Table 4.3: threshold 0.35, improved 0.16
From 24 March 2027
AD L 2026 Tables 3.2 and 3.3
Escape window
0.33m2 and 450mm by 450mm minimum, per AD B 2.10

A roof window cut into a worn slope only moves the leak, so the slope is checked first.

Fig. 2 Roof windows, drawn close

Callout 2 of 3

Insulation under the slope and the spray foam question

Insulation decides where a roof's moisture goes. In a cold roof the insulating layer lies at ceiling level and the slope above it stays cold and ventilated. In a warm roof the insulation follows the slope, putting the timbers on the warm side of it. Either arrangement can be sound, and the survey says which a Culmington house has before anyone suggests changing it. We photograph the underside of the covering at the ridge, mid-slope and the eaves, so the three zones can be compared.

Condensation leaves dark spotting on the underside of the covering and on the rafters, and it can be mistaken for a leak. A leak stains around one hole or flashing, whereas condensation tends to spread across a whole slope. We note which pattern we see, because the repair differs.

Spray foam is the case that raises the most questions. The Energy Saving Trust describes two kinds. For closed-cell foam it names "its main drawback" as being "not vapour permeable", and it calls open-cell foam "the more vapour permeable", and on rot it expects the risk to be "much lower" with that type once foam has been sprayed against the underside of the roof. The word is should, and the survey looks at the timber instead of taking the foam type on trust.

Lending is a separate matter. RICS reported concern among lenders in March 2023, with equity release mortgages named as an example, and it advises owners to put the question to their mortgage provider before foam goes on. Ask again before a sale, and keep each reply in writing, because the answer can change the plan.

Where foam is already on a slope it hides the rafters and battens. We record which type it appears to be, photograph every edge that can be seen, and look for stains on the ceiling below and for soft timber at the eaves. Taking foam off is a job in its own right, and once it is off the timbers are examined again before any new insulation goes in. Our spray foam insulation removal page explains how that work is approached. A roof that is simply cold and under-insulated is an easier case, and the Table 4.3 figures above are the ones to aim for when it is renovated.

Checked under a Culmington slope

  • Whether the roof is cold or warm
  • Rafters and battens seen from the loft
  • Any foam on the underside, and its type
  • Stains on the ceiling below
  • Gaps at the eaves that let air through
Fig. 3 The slopes, drawn close

Callout 3 of 3

All Saints, Tudor Lodge and the Culmington listings

The wall head is where the roof ends against old masonry, and in Culmington the National Heritage List puts these buildings at that callout.

Culmington buildings named on this page and their list entries
BuildingGradeList entryFirst listed
Church of All SaintsII*126990712 November 1954
Tudor LodgeII126991415 March 1974
Culmington HouseII126991321 June 1996

The barn about 20 metres north-west of Culmington Farmhouse is Grade II as well (list entry 1269910, first listed 15 March 1974). All Saints is Anglican, and while it serves as a place of worship its roof falls under the faculty system, not the council's listed building consent. The houses are the other way round. A new roof window on Tudor Lodge is a consent question before it is a fitting question.

Two questions run side by side on a listed house, and answering one does not answer the other. Building Regulations ask how much of the roof is touched: the Planning Portal's test is whether less than 25 per cent of the building envelope and less than 50 per cent of the roof is affected. Listed building consent, under section 7 of the 1990 Act, asks whether the work changes the house's character at all, however small the area. Neither takes the place of permitted development rights a house keeps. On a listed house, or one in the conservation area, the covering that goes back is matched to the one that came off in size, colour and fixing, and the proposal reaches the council with our photographs of the existing roof.

Shropshire Council records a conservation area named Culmington, and the council can confirm where its boundary lines fall. Check whether an Article 4 direction applies with Shropshire Council. Where one covers a street, some permitted development rights have been taken away. A licence under section 169 of the Highways Act 1980 is needed for scaffolding that occupies the highway, and our scaffolder is the firm we arrange it with. A scaffold also gives safe access to the verge and the ridge, where the survey finishes.

For building control, Shropshire Council Building Control answers on 01743 258710, and a registered building control approver can be used instead. Our listed and heritage roofing page explains how we plan around a protected house.

A roof edge on a Culmington house

SoundVerge pointed, flashing seated, wall below dry
Needs workMortar lost at the verge, gap at the wall, stain below

Culmington lofts, foam and listings answered

Does a roof window in a Culmington loft need a planning application?

Under the English rules a roof window counts among alterations to the roof, and the conditions that govern it are in our planning guide. Before a dormer or roof window is drawn, ask Shropshire Council whether the house is in the Culmington area. A listed house needs listed building consent as well. Building Regulations then ask for 1.4, or WER Band B, for the window itself.

What escape route does a Culmington loft conversion need?

With a storey above 4.5 m, AD B paragraph 2.5 offers two choices, a fire-protected stairway or an upper floor sealed off with a route to its own exit, and paragraph 2.23 adds sprinklers for open-plan layouts. An escape window must have an openable area of at least 0.33m2, with its bottom edge no higher than 1100mm from the floor. Building control checks the layout before the work closes up.

Does spray foam under a Culmington slope affect a mortgage?

RICS reported concern among lenders in March 2023, with equity release mortgages named as an example, and it suggests raising the matter with your mortgage provider. Ask before foam goes on and again before any sale of the house, and keep the answer in writing. Lenders differ, and foam already on the roof is a question for the buyer's lender too.

Is open-cell foam safer for the timber than closed-cell under a roof?

Closed-cell foam is, in the Energy Saving Trust's words, "not vapour permeable", while open-cell is "the more vapour permeable". The Trust puts the rot risk as one that "should be much lower" with open-cell foam, which is a hedge, not a promise. So the timber under the slope is inspected for staining or softness, whichever type has been sprayed on it.

Does a roof repair at All Saints church in Culmington need council consent?

All Saints is Grade II* (list entry 1269907, first listed 12 November 1954). It is an Anglican church, and while the church is in use the faculty system covers its works, so the council's listed building consent does not apply. A sung Evensong from the Book of Common Prayer takes place there monthly. A church that had closed would be treated differently, so the churchwardens hear from us before any scaffold or price.

What do Tudor Lodge and Culmington House need before a re-roof?

Tudor Lodge (list entry 1269914) and Culmington House (list entry 1269913) are both Grade II, so listed building consent from Shropshire Council comes first for work that affects their character. The Shropshire Council licence for scaffolding or hoarding is £200, and it asks for ten working days, Saturdays excluded. We arrange that licence with our scaffolder, and the written total takes the scaffold into account.

Thinking of a loft room in Culmington?

Tell us about the roof and give the address; we survey the loft first and write one total.

10-year workmanship guarantee, in writing