01432 610152 Get a quote Call 01432 610152

Roofers in Clifford

Stone slate, slate and lead roof work in Clifford, west of Hereford.

A survey from the ridge down, photographs of every fault and one total price put in writing for you.

Get a free quoteCall 01432 610152

Stone slates, church lead, a Grade I castle

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Stone slates and modern slatesThe 1931 inventory recorded monuments 6 to 17 with stone or modern slate roofs.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Tiles and lead on the churchSt Mary's was recorded in 1931 with roofs covered in tiles and lead.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Castle, Lower Court, Upper CourtClifford Castle is Grade I; Lower Court and Upper Court are both Grade II*.

Clifford and the miles from Hereford

Clifford on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Clifford roofs from stone slate to lead

Clifford in three callouts: stone slate slopes, church lead and listed eaves

This read follows a survey in order: the slope first, where stone slates and slates are recorded in the parish, then the lead that keeps a church roof watertight, then the eaves of the listed houses and the consents they need.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Stone slate; 2 Church lead; 3 Listed roofs.

Fig. 1 Border house in section, with the Clifford callouts numbered in survey order.

Callout 1 of 3

Stone slates and the quarries that supply them

Our first callout is the slope itself. The Royal Commission's inventory for south-west Herefordshire, published in 1931, says of monuments 6 to 17 in Clifford parish that "The walls are of stone rubble and the roofs are covered with stone slates or modern slates." A stone slate is a thin slab of sandstone, split and dressed, then hung on a peg or a nail. SPAB describes slate and stone roofs in this region as "predominantly double-lapped", which means each unit covers the joint below it and is itself covered by the course above. Whatever sits on your own slope, the survey identifies it before anything is priced, because a repair that mixes the two coverings has to suit both.

Stone slates fail in recognisable ways. A slab can delaminate, shedding thin layers from its face. A peg or nail can corrode and let a slab slip. A cracked unit lets rain reach the timber beneath it. We go over the slope course by course and photograph each damaged slab, working from a ladder or tower so that the stone is not walked on. Sound slabs that have simply slipped are rehung. Cracked ones are replaced from reclaimed stock or from a quarry. SPAB warns that old stone roofs have often been swapped for different stones, for slates or for imitation stone slates. That is a decision to take with your eyes open, because the look and the weight both change.

Cleaning is gentle on stone slates. Moss and lichen are brushed off by hand, nothing harsher than a stiff brush goes near the stone, and the gutters below are cleared at the same visit so the moss does not end up blocking the downpipes.

Weight matters because AD A counts a loading increase of more than 15% as a significant change. Moving from stone to a lighter covering is a smaller structural question than the reverse, though either one is a change of covering. For a house in England the Planning Portal sets the line for a re-roof at under 25 per cent of the building envelope together with under 50 per cent of the roof, below which no application is normally needed. We tell you which side of that line a job falls on at the survey. Our pitched roofing page explains the coverings and fixings we work with on slopes of every kind.

Matching stone

Where does matching stone come from when a Clifford stone slate fails?

The county's stone atlas points to the St Maughans Formation sandstones, with a handful of quarries still cutting them. SPAB tells owners to test every answer of "unavailable" by asking the quarries directly.

A cracked stone is lifted out and photographed before anything new goes in beside it.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Tiles and lead on the parish church

At Clifford, the church of St Mary is recorded in 1931 as roofed in "tiles and lead". That pairing is worth a callout of its own, because lead is where a tiled roof is made watertight. Sheet lead is dressed round a junction, tucked into a mortar joint on one edge and laid over the tiles on the other. Lead cut into small pieces and slipped under each course at the side of a wall or stack is called a soaker. Lead laid in the trough where two slopes meet is a valley gutter. Each of these wants a different thickness of sheet.

Royston Lead's brochure sorts its sheet into numbered codes by use. Code 3 is marked "Recommended for lead soakers only", while Codes 4, 5 and 6 are all listed for flashings. Codes 5 and 6 also cover parapet and box gutters. We choose a code to suit the junction and dress the sheet so it can move with the temperature without tearing. Where a valley gutter has worn through, the lead is relaid in fresh bays and the tiles either side are rebuilt to match. Lead that has split, lifted or worn thin is replaced, because smearing sealant over it hides the fault for a season at best.

Lead has a long life when it is fitted properly. MyJobQuote says correctly installed lead flashing "can last for over 80 years", and HomeBuilding gives a lead flat roof as "60-100 years". Both are typical ranges, not promises. A lead roof sits outside BS 6229, which covers flat-roof membranes only, so a lead job is judged on its detailing and on the size of each bay rather than on a fall figure. Our lead roofing page sets out the junctions we dress and how each one is photographed before and after. Both faces of a junction are shot, so you see the lead and the tiles it protects.

A church roof raises one more question before anything is ordered. St Mary's at Clifford belongs to the Church of England; the faculty jurisdiction governs its roof for as long as worship continues, which leaves the council's listed building consent out of the picture.

Lead codes by use, from the maker's table

Code 3
Recommended for lead soakers only
Code 4
Used for soakers and flashings, among others
Code 5
Used for flashings and for parapet and box gutters
Code 6
Used for flashings and for parapet and box gutters
Fig. 3 Leadwork, drawn close

Callout 3 of 3

Castle, courts and consent on listed Clifford roofs

The third callout is the eaves and the rules around them. Clifford Castle and Barbican is listed Grade I (list entry 1167903, first listed on 17 January 1949). Lower Court carries Grade II* (list entry 1348895, first listed on 16 November 1984), and so does Upper Court (list entry 1099497). Listed building consent, under section 7 of the 1990 Planning (Listed Buildings and Conservation Areas) Act, covers works that would affect a house's special character. The house keeps its permitted development rights, but consent is needed alongside them, so we settle materials and method with Herefordshire Council first. Our listed and heritage roofing page describes how we work on protected houses.

Herefordshire has 64 conservation areas, and Herefordshire Council's own conservation area list is where an address is checked, because a boundary can matter for a dormer, and an Article 4 direction for more, even where a repair is unaffected. Article 4 directions withdraw specified permitted development rights over a defined area, so check whether one applies with Herefordshire Council. Our planning guide for roof windows covers the rules for a new window in the slope. On the energy side, AD L 2021 Table 4.2 sets 2.2 for a rooflight and 1.4 or WER Band B for a roof window.

Herefordshire Council Building Control sits at Plough Lane in Hereford and is reached on 01432 261938 or at bce@herefordshire.gov.uk. A registered building control approver is the alternative. Structural work, a change in the weight of the covering and any insulation upgrade belong with one or the other. At the eaves we also look at the gutter, the fascia and the wall plate beneath, since a leak there rots timber out of sight, and our photographs show you the board behind the gutter before it is closed up again.

If the eaves hold a bat roost or a nest, the work waits. Bat licences come from Natural England, and a nest that birds are still building or occupying is protected. The survey notes any droppings, staining or gaps at the eaves that point to a roost, so the question is raised before the first board is lifted and not halfway through the job.

The eaves course at a Clifford house

SoundGutter runs true, fascia dry, wall plate firm
Needs workSagging gutter, wet fascia, soft timber behind the board

Clifford roofs: stone, lead, bats and consent

How is a stone slate roof in Clifford repaired when slabs crack or slip?

Each damaged slab is marked and photographed, then either rehung if it is sound or replaced if it has cracked or flaked. Replacement stone comes from reclaimed stock or a quarry, and SPAB advises checking any claim of unavailability with the quarries. The 1931 inventory also records modern slates in the parish, so some roofs combine both coverings, and a repair has to suit whichever sits on your slope. Sound slabs are always reused first, since a stone already on the roof matches the rest of it.

At what point does a Clifford re-roof go to building control?

Clifford is in England, so the Planning Portal tests apply: a job inside both limits, under 25 per cent of the building envelope and under 50 per cent of the roof, is normally left without an application. Past that line, building control decides. A covering heavier by more than 15% needs a structural check under AD A. Insulating at the same time brings in AD L 2021 Table 4.3, with AD L 2026 Table 3.3 due from 24 March 2027.

Where do I check a Clifford address against conservation area boundaries?

Herefordshire Council keeps the list and can tell you whether a boundary takes in your address, so ask before planning a dormer or roof window. Herefordshire has 64 conservation areas in all. Like-for-like repairs raise different questions from new windows, and the planning guide linked above covers the windows. An Article 4 direction, where one applies, narrows what a house may do without an application.

Do roof repairs at a listed Clifford house need consent?

Works touching the special architectural or historic interest of a listed house require listed building consent, and Herefordshire Council decides. Permitted development rights remain with a listed house, but consent is also required. Because even a simple repair can change the character of a Grade II* roof, we put the question to the council before work starts and agree the materials in writing.

What happens if bats turn up in a Clifford roof?

Work stops until the position is clear. Under the Wildlife and Countryside Act 1981 s9(4), disturbing a bat is an offence if done intentionally or recklessly, and regulation 43 of the Habitats Regulations protects the place where a bat breeds or rests whatever the intent. Licences come from Natural England. A roost in the eaves of an older stone house is a reason to rearrange the work, not to skip the check.

What notice does Herefordshire Council want for scaffold at a Clifford house?

A Herefordshire Council scaffold licence costs £167 for a maximum of one month, £123 for any month beyond it. The application must reach the council at least 10 days before erection. We arrange the licence with our scaffolder, and the cost sits within your single quoted total. Highways Licensing at Herefordshire Council takes calls on 01432 261800. National Highways, not the council, runs any trunk road or motorway.

Request a Clifford roof survey

Tell us the address, attach a picture of the worst corner, and we will fix a survey date.

10-year workmanship guarantee, in writing