Callout 1 of 3
The ridge line on red tiled roofs
The survey of a Birtsmorton roof starts at the ridge, the horizontal line where two slopes meet at the top. The Victoria County History of 1924 gives Birtsmorton Court, the moated house that stands near the church, "red tiled roofs and brick chimneys". That describes one house, not the village, and a colour is not a material, so we identify the tile itself on every roof: clay and concrete age differently, and the right repair depends on which is in front of us. The capping tiles that cover the ridge sit on a mortar bed, or are fixed dry, held by clips and screws instead.
Marley, the tile maker, states that "Installing to BS 5534 isn't required by law", and adds that after the 2015 amendments mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612 is the standard for dry-fix. Mortar is therefore not banned, and a bedded ridge can stay bedded, but each capping tile gets a mechanical fixing as well. On an older house that keeps the look and adds the grip.
A hand on each capping tile finds the ones that rock, and a look along the mortar finds open or crumbling joints. The tile at each gable end shows whether the verge below is holding, and where a roof has hips we check the point at which they meet the ridge, since several lines of weather arrive together there. The BRE's minimum life of 60 years is a figure for clay tiles alone. Concrete tiles are a different case: Marley says "around 60 years" and HomeBuilding gives "40-50 years" for plain ones. Those are ranges, not promises about your roof.
Beside the ridge, the verge, where the roof ends at a gable wall, is examined from a ladder and from inside the roof space. Verge mortar that has dropped out leaves the end of each course unprotected, and a gap at the barge board can admit rain to the rafters. We record each gap with a photograph and a position, so the repair is described to you in terms of where it sits on the house.
Rebedding a ridge means lifting the capping, clearing the old mortar and fixing each tile back, and we photograph the top course while it is bare. For a re-cover, the Planning Portal draws its line in England at less than 25 per cent of the building envelope together with less than 50 per cent of the roof; below that, no application is normally needed. Our pitched roofing page covers the larger job.
The ridge of a Birtsmorton roof
- Capping tile
- Covers the ridge line, bedded or clipped
- Bed
- Mortar or dry-fix, with a mechanical fixing too
- Hip joint
- Where hips meet the ridge, checked for open mortar
- Gable end tile
- Shows whether the verge below is holding
- Top course
- Photographed bare while the capping is off
A colour is not a material, so the tile is identified before a repair is proposed.















