In brief
MyJobQuote's Velux page, updated on 22 September 2026, says that Velux window replacement costs "around £100 less for a straightforward swap, as the opening is already in place". That is a comparison, not a total. What a swap costs on your roof turns on the covering, the height, the dimensions of the unit and the state of the timber around the opening. After the visit to your roof, the price arrives as one total in writing.
What the swap saving does and does not say
MyJobQuote's sentence sets two kinds of job side by side. A new opening means cutting through the covering and the structure and framing a hole. A swap uses a hole that is there already. The page puts the second at around £100 less, and gives the reason in the same breath: the opening exists. Picture two quotes for the same unit on the same roof, one reusing the hole and one making it. The dearer carries the cutting and the new framing that the swap skips.
Two cautions go with that. First, the word "straightforward" carries weight. If the old frame has rotted, or the new unit is a different size, the job stops being straightforward and the saving may go. Second, MyJobQuote shows no VAT basis on its page, so the saving cannot be read as a figure with VAT or without it.
The page gives a direction, and a direction is not a price. It tells you to expect a swap to come in under a new opening, and to ask questions when it does not. It cannot say what either costs on a stone cottage or a brick semi, because the building decides that.
What moves a Velux total up or down
These are the matters that set a total, in the order we meet them on a roof.
| Point | What it changes |
|---|---|
| Covering | Tile, slate and lead each take a different flashing kit |
| Opening | Same size is a swap; a different size means carpentry |
| Height | Decides scaffold or tower, and how long it stays |
| Timber | Rot around the frame must be cut out first |
| Unit | Size, glazing and how it opens alter the product price |
| Lining | Plaster and paint indoors are made good |
The product alone is a separate question, covered by the small Velux price. How the kit for each covering differs is on the page about flashing kits for tiles and slate. Neither the swap saving nor the product price covers the work between the two, and that is the part a survey has to measure.
A swap runs in a set order: the scaffold or tower goes up, the old sash and flashing come out, the frame and the timber round it are inspected, the new frame and flashing go in, the covering is dressed back and the lining indoors is made good. Any step can be the one that moves the total, so we photograph the frame as it comes out.
Rules that can add steps to the job
A replacement roof window has to meet the window line of Approved Document L, which is 1.4 or WER Band B under Table 4.2 for England and under Table 4.1 for Wales. A unit picked for its price alone may fail that test, and the roof window U-value answer sets out the numbers.
Permissions can add time. Under England's Class C, a conservation area does not by itself bar a roof window; that is Class B's rule for dormers. Across the border, Welsh Class C.1(d) puts the insertion of a roof light outside permitted development in a conservation area or the National Park, so ask the council whether a swap there needs an application. The Welsh Government adds that new rooflight work will generally need Building Regulations approval.
Listed buildings need listed building consent on both sides of the border, and in England the householder rights do not reach a flat. A first call to the council can save a wasted order. Put the question to the council before you order the unit, file the reply with the quote, and keep the data sheet for the new window with them.
Reading the written total
Our total is a single figure, given after the survey. The scaffold is in it. A scaffold on a public road needs a Highways Act 1980 s169 scaffold licence, and we arrange the licence with our scaffolder.
Our total says what it includes. Hold any quote, ours or another firm's, up against these questions, and note the answers down:
- Is the make and model named, so the product is pinned down and not just described?
- Is the flashing right for your covering?
- Does the opening stay the same size, or is it changing?
- Are VAT and scaffold in the total, yes or no?
- Is the old unit removed and the lining made good?
- Is there a date until which the price holds?
If two quotes differ, ask what is different in the roof or the work, not in the wording. We photograph the existing unit, the flashing and the timber at the survey so you can show any other firm the same facts. The whole group of pages sits under Velux and skylights.
