Two very different problems produce the same stain. A leak is water from outside finding a way through the covering. Condensation is water that comes out of the air inside the house, when warm, damp air touches something cold and drops its moisture as droplets. A homeowner sees a brown ring on a ceiling or damp patches in the loft and reaches for the phone, but the repair for a leak, new tiles or a flashing, does nothing for condensation. Likewise, a vent in the wrong place will not stop a slipped slate.
Telling them apart is mostly a matter of pattern. Timing, position and the look of the damp give most of the answer before anyone climbs a ladder. Some roofs have both problems at once, which is why a careful look matters.
This guide sets out the clues, the checks you can make safely from the ground and the hatch, and the order we follow on the roof itself. It also covers what changes between England and Wales if the cure turns out to be new insulation or a new covering. For a full run of repair work, see our roof repairs page.
One stain, two possible causes
A leak needs rain, or at least wet weather, to work. Water that has got past a tile, a flashing or a gutter runs along the underlay or a timber until it finds somewhere to drip. The damp tends to appear after rain and to ease in dry spells, though an old leak can carry on for a day or two while soaked timber and insulation dry out, which is why a patch seen on a dry morning is not always proof of anything else.
Condensation does not need rain at all. A household puts moisture into the air all day: cooking, washing, showers, wet laundry, even breathing. Over a day, that adds up to a lot of vapour for a loft to cope with. That air rises, finds its way into the loft through gaps round the hatch, light fittings and pipes, and meets cold timber and the underside of the covering. Moisture then settles as beads of water, which can drip or soak the insulation.
The problem is that the results look alike. Both give:
- a damp patch or brown ring on a ceiling
- wet insulation or stained timber in the loft
- mould on rafters, battens or the back of the underlay
- drips from nail tips or the roof felt
The difference lies in the pattern, which is what the next section reads. Our guide to finding a roof leak covers the tracing of a genuine leak from the stain back up to the gap.
Reading the pattern
Before anyone goes up, five questions narrow the field. When did the damp show? Where is it? How big is it? What does it look like? Does it change with the weather?
| Clue | Leak | Condensation |
|---|---|---|
| Timing | During or just after rain | Cold mornings, with or without rain |
| Spread | One patch below one spot | Wide, across a whole slope or room |
| Look | A tide mark or a steady trickle | Beads of water, or black spotting |
| Weather link | Worse in wind-driven rain | Worse in a cold spell, better when mild |
None of these is a proof by itself. A leak that has been running for a season can spread across a ceiling and look wide. Condensation that sits in one corner above a bathroom can look like a single fault. Treat the table as a way of choosing where to look first, not as a verdict. When the clues split evenly, assume both causes may be present and test each in turn.
Location adds a clue of its own. A leak sits below something on the roof: a chimney, a valley, a ridge or a broken tile. Condensation tends to gather in cold, poorly ventilated spots, such as the north-facing slope, the roof corners and the eaves, and above rooms that make a lot of steam. If the damp lines up with a bathroom or kitchen, ask first where its air is going.
Checks you can make safely
You can learn a lot without leaving the ground or climbing into the loft. Start with a record. Note the date and the weather each time a mark appears, and photograph it with a coin beside it to show the size. After a fortnight, the log may show whether the damp follows rain or follows cold nights.
These checks help:
- Look at the ceiling on a dry, cold morning and again after rain. A patch that is wet in both is not rain alone.
- Open the loft hatch and look, without stepping in. Beads of water hanging from the back of the covering, or from nail ends, point to condensation. A single wet timber or a dripping spot points to a leak.
- Run a hand over the loft insulation near the eaves. Damp that is even across it suggests moisture from the house.
- Check that vents are open, and that nothing has been stacked against them: eaves vents, bathroom fans and cooker hoods should discharge outside, not into the roof space.
Do not poke at a bulging ceiling, and do not go onto the roof. A ladder against a wet slate or a mossy tile is how a damp patch turns into a hospital visit, and the evidence will still be there when a roofer arrives. If a ceiling is sagging with water, empty the room below, and have the electrics in it isolated before anyone goes near the wet area. Our guide on water in the loft after rain covers the immediate steps for a wet loft.
Where the damp air comes from
When condensation is the cause, the roof can be the place the damp shows, not the place it starts. The moisture is made in the living space, so the cure begins there. Common sources are:
- showers and baths, especially in a room with no working fan
- cooking without a cooker hood that vents outdoors
- clothes drying on radiators or racks indoors
- unvented tumble dryers, or a vent pipe that ends in the loft
- bathroom or kitchen fans that exhaust into the roof space rather than through it
The route that air takes into the loft matters as much as its source. Gaps round the hatch, recessed light fittings, cable and pipe holes through the ceiling and loose-fitting boxing all let warm air rise. Sealing those gaps keeps damp where it can be dealt with, in the rooms below, by a fan or an open window. A draught-strip round the hatch, and a hatch that sits down firmly on it, cost very little and make a real difference.
The loft itself should be cold. If insulation has been added, check that it has not blocked the gap at the eaves, because that is where cool air enters the roof space to carry moisture away. A common fault is insulation stuffed hard into the eaves, and a tide of dark staining on the rafters just above it shows how long the damp has sat there. Pulling it back a little can bring air flow back, and where a ventilation tray is needed it keeps the gap clear.
A roof with condensation can need less work than a roof with a leak, and sometimes none at all on the covering.
Ventilation, underlay and the standards behind them
The right amount of ventilation depends on the make-up of the roof. Marley publishes its ventilation figures for a cold roof. Where the sheet is high resistance (HR), it asks for an eaves gap of 25mm along the length for pitches of 15° or less, and 10mm for steeper pitches, because that sheet passes no vapour. An air-permeable sheet (LR) over a well-sealed ceiling is treated differently: the ordinary 3mm of eaves construction does the job, as long as the maker's UKAS certification conditions hold.
The standard behind this, BS 5250, is current and under review. In England, Approved Document C (2013), paragraph 6.10, meets the condensation requirement by reference to Clause 8.4 of BS 5250:2002 and BS EN ISO 13788:2002. For a Welsh address, ask the council's building control service or a registered building control approver which document applies.
Spray foam on the underside of a roof changes the picture. The Energy Saving Trust separates the two main foam types by vapour: closed-cell blocks it, open-cell lets more through, and on timber rot the Trust says the risk should be far smaller with open-cell foam. Foam hides timber, so condensation and slow leaks behind it may not show until damage is advanced. If foam is present, say so when you call.
Fixing condensation can mean new insulation. Under the Energy Saving Trust and building rules, that is a renovation, which brings the following limits.
- In England, AD L Table 4.3 sets a threshold of 0.35 and an improved value of 0.16 for a roof.
- In Wales, AD L Table 11.1 sets 0.16, and not worse than 0.35 where 0.16 is not feasible.
When it is still unclear
Some roofs defeat a first look. A leak and condensation may be present together, or a leak may be so slow that it behaves like damp air. In those cases we go through the roof in steps.
We begin in the loft, in daylight, with the hatch open and a torch, checking the underside of the covering, the insulation and the timber. Then we check the outside, from the ridge down. If the cause still does not show, a water test settles it: a hose, on a gentle setting, played across a single patch of the slope at a time, moving up the slope, while someone watches the loft. The moment a drip starts shows which patch to open. We use a hose and never a jet, since high-powered jet washes can damage slate and tile surfaces.
The findings come with photographs of what we saw on your own roof. If the cause is a leak, we quote the repair as one written total. If it is condensation, we tell you plainly, even where that means no work on the roof, and explain what to change inside the house.
For a sense of cost, Which? surveyed Trusted Traders in November 2025 and found clearing all gutters £75 to £350, excluding VAT. MyJobQuote lists the 2026 average for ridge tile replacement as £225 to £550, and its roof repair average at around £650. Our guide to a ceiling stain after rain explains what to do while you wait for a visit, and what to photograph before anything is moved.
