In brief
On our survey, yes. The gutters, downpipes, fascias and eaves are part of how the roof sheds water, so we check them from a ladder and photograph what we find: joints, brackets, falls, blockages and damp marks on the wall below. The manufacturer Brett Martin sets the fall at 1mm for every 600mm. Cleaning is a separate job from checking, and it is priced as part of the written total.
What we check along the gutter line
The gutter is where the roof ends, so the eaves tell you a lot about what is happening above. We work along the whole run, front and back, and on each length we look for the following:
- joints that have opened or been sealed more than once
- brackets that have pulled away, letting the gutter sag
- cracks, splits and corrosion in the gutter itself
- silt, moss and seeds lying in the channel
- outlets and downpipes that are blocked or not connected
- wet staining on the wall, a sign that water is missing the gutter
Behind the gutter sits the fascia, the board that holds the gutter up, and under the overhang runs the soffit, which boxes in the underside of the overhang. We press and photograph any section that looks soft. Alongside that we look at the lowest courses of the roof covering, where tiles or slates meet the gutter, because a fault there can show up as a gutter problem first. Your photographs show the run from end to end, with a close view of each fault.
Fall, joints and why they matter
A gutter has to slope toward its outlet, or water lies in it and overflows at the nearest low point. Brett Martin's guidance on installing guttering is "1mm for every 600mm". The slope is slight enough to vanish when one bracket drops. Water that stays in the channel for hours after a shower means the fall has gone or something is blocking the flow.
Joints are the other weak place. A union (the joint between two lengths) is sealed with a rubber gasket or a sealant, and when that fails it drips onto the wall below. Repeated dark streaks at one point point to the joint, not to the roof.
Seeing the fall properly needs a spirit level or a hose test, and neither belongs on a visual-only inspection. What the ladder gives is the sag and the pooling, and a photograph of both. If the run needs to be taken down and refitted, that goes into the written price as a recommendation, with the reason shown in the pictures. The roof inspections page explains how those photographs feed into a repair price.
What gutter work costs, from the published guides
These are national figures from named guides, not our prices. Each one keeps its own unit, and none should be multiplied up.
| Job | Figure | Source |
|---|---|---|
| Clearing all gutters | £75 to £350, ex VAT | Which?, November 2025 |
| Gutter replacement | Average £1,000 to £1,600 | MyJobQuote |
| uPVC gutter | £40 to £50 per metre | MyJobQuote |
| Capping fascias and soffits | Average around £800 | MyJobQuote |
A range this wide reflects how many metres of gutter there are and how high the eaves sit. Access decides a good deal, and any scaffold is named in our written total, along with VAT, so it does not arrive as an extra. When scaffold stands over a footway, the licence under the Highways Act 1980 s169 is arranged by us with our scaffolder. Clearing sits at the low end of the table because it adds no new parts, only labour, and it is worth repeating on a house with trees close by. Replacement costs more because it brings new lengths, brackets and joints.
Our price arrives once the survey is done, as one written total, and a guide figure is only a yardstick for testing it.
When the gutter points back to the roof
Gutters can take the blame for faults that start higher up. An overflow at the foot of a valley can come from a blocked valley channel. Slates or tiles that have slipped can drop debris into the gutter. A fascia that has rotted may have been wetted for years by a failed edge on the roof above. A wall that stains below a bracket may point to a leaking joint, or to a roof edge that sheds water over the gutter lip.
That is why the gutter check belongs with the roof check, not apart from it, and why we start high and finish at the eaves. A gutter that is clean and level but still overflows has a different cause from one that is full of silt. Our photographs let you see which you have before anyone quotes for new guttering.
If the survey shows tired guttering and a sound roof, we say that the gutters are the job and the roof is not. For the checks above the gutter, what a roofer checks on an inspection works through the whole roof in order, and an autumn roof inspection explains why leaf fall is a good time to look.
