01432 610152 Get a quote Call 01432 610152

Rainwater route

Downpipes, hoppers and drains: where roof water goes

Roof water leaves the house through a gutter, a hopper or outlet, a downpipe and a drain. A fault at any point shows up as damp or staining somewhere else.

Horizon Roofing Hereford 9 min read

Plenty of owners look at the gutters and forget what happens next. The gutter collects water from the roof edge and carries it to an outlet. From the outlet it falls down a pipe, sometimes through a hopper on the way, and reaches a gully or drain at ground level. Each link depends on the one before it, and a problem at the bottom, such as a blocked gully, backs water up all the way to the roof edge.

That is why a wet patch on a wall may not point to the place you first suspect. A leak at a downpipe joint can run down the wall for two metres before it shows. A blocked hopper can overflow onto a window head. A cracked gully can soak the base of a wall where the damp then rises indoors.

This guide traces the path water takes down from the eaves to the drain, names each part, and explains how it fails and what the repair involves. It also covers the one material that needs special handling: asbestos cement rainwater goods, with the waste rules in each country. Our page on the whole roofline is guttering, soffits and fascias.

Following the water from the roof edge down

Roof water is collected at the eaves and carried a short distance sideways before it drops. The parts, in order, are these:

  1. The gutter: the channel under the roof edge, laid to a fall so water runs toward an outlet.
  2. The outlet: the opening in the gutter, or the stop end beside it, where water leaves the run.
  3. The hopper, where there is one: a box or funnel at the top of a downpipe that receives water from the gutter, and sometimes from a pipe at an upper floor.
  4. The downpipe: the vertical pipe, fixed to the wall with brackets or ears.
  5. The shoe: the bend at the foot of the pipe that turns the flow toward a gully.
  6. The gully or drain: the opening at ground level that takes the water away.

The gutter's fall is the first thing that sets how well the whole route works. The gutter maker Brett Martin gives "1mm for every 600mm", which means a run of eight metres falls by about 13 millimetres. Too little fall leaves water standing, and standing water carries leaves and moss toward the outlet, where they settle and slow the flow even more.

The outlet sits at the low point of the run. If it is moved, or the downpipe is repositioned, the fall must be reset too. Our guide to clearing a blocked downpipe covers the first thing to try when water stops draining.

Hoppers: what they do and how they fail

A hopper, also called a hopper head, is the box or funnel that tops a downpipe. On an older house it can be cast iron or lead, and it may carry a date or a pattern. On a newer house it is plastic. It does a useful job: it takes the discharge from the gutter and, in some houses, from a waste pipe or a roof valley, and gives it a wide, forgiving mouth to fall into.

The same shape also catches debris. Leaves, moss, a dead bird or a tennis ball can sit in the hopper and block the flow, and the water backs up and runs over the rim. Look for these signs from the ground:

  • staining or green growth on the wall directly below a hopper
  • water running over the front of the hopper in rain
  • a hopper leaning off the brickwork, with a gap behind it
  • rust bleeding from the seams of an iron hopper, or splits at the corners

Old hoppers can be cleaned, repaired and refixed. Sound iron can be rubbed back and repainted, and a split seam on an iron or plastic hopper can sometimes be sealed. A hopper that is cracked through, or lead split along a fold, is better replaced in the same pattern. A like-for-like replacement keeps the look of an older house, and the wall behind it is checked for damp before a new one goes on, because a hopper that has leaked for years leaves the brickwork saturated. Our note on cast iron gutters on period homes covers the consent questions for listed buildings.

Downpipes: fixings, joints and the shoe

A downpipe is simple, and its faults are simple too. The usual suspects are a joint that has come apart, a bracket that has worked loose from the masonry and a pipe blocked by debris or frost. A leaking joint is easy to spot after rain, because the wall below has a dark streak and sometimes a green stain that gets worse each season.

What we check on the pipe itself:

  • Whether each socket still holds the pipe above it, with its joint sealed.
  • Whether the pipe is plumb, with no lean at the top where the bracket has dropped.
  • Whether brackets are tight in sound masonry or timber, not just in old mortar.
  • Whether the shoe at the foot points into the gully rather than at the wall.

A pipe that discharges onto the wall or the path instead of into a gully splashes the lower brickwork or stone. Over a winter, that can cause damp, algae and frost damage at the base. Our guide to a damp wall below a gutter explains how to tell this from a roof leak. A downpipe can be replaced without removing the gutter if the outlet is sound, and short repairs, such as a new bracket or a resealed joint, take very little time on site. Where a pipe is to be moved, building control is the body to ask, because it may change where the water goes. A pipe on a boundary wall or a shared terrace also raises the question of who owns it, and that is worth settling with the neighbour before work starts.

Gullies, drains and where the water ends up

At the bottom of each pipe, the gully is a trap with a grating, and it clogs with silt, leaves and grit. It then holds water at the base of the pipe, and the pipe backs up. A drain beyond the gully can be blocked by roots or collapsed. A blocked gully is cleared by hand or with rods, and a collapsed drain is a job for a drainage firm, not a roofer.

The table sets out what each symptom suggests, so you know where to look first.

Symptoms and the part to check
What you seeCheck first
Water spilling from the gutter edgeThe outlet and the fall
Water over the front of a hopperDebris in the hopper
Dark streak down the wallA downpipe joint
Pool at the foot of the pipeThe gully and the drain

The gully is also where roof water meets the ground, so its position matters. If it sits at a low spot beside the wall, water can pool and soak the foundations. Whether a drain can take extra water, or be redirected, is a question for building control and the water company, not for guesswork from the ground. We note where the pipe discharges at the survey, photograph it, and tell you if the problem is below ground. A drainage firm then takes it from there, and the roofline work carries on separately, so one job does not hold up the other.

Asbestos cement rainwater goods and the waste route

On an older garage, outbuilding or house extended in the last century, downpipes, hoppers and gutters may be asbestos cement. HSE's non-licensed work page covers "asbestos cement products, (eg roof sheeting and rainwater goods) provided the material is carefully handled/removed without breaking up", and says that "If the building was built or refurbished before 2000, assume that there is asbestos in it." A cracked pipe or hopper moves into notifiable non-licensed work once the cement is "substantially damaged or broken up". Lifting a sound piece away whole is the safer route.

The waste then follows the rules for each side of the border:

  • England: the household consignment-note exemption covers domestic hazardous waste "other than asbestos waste", so asbestos waste is outside it.
  • Wales: Natural Resources Wales says "contractors moving asbestos from a domestic property will need to use consignment notes".
  • Herefordshire, in England: asbestos that is double bagged and sealed may go to the Hereford or Leominster centre, booked, from Herefordshire residents only.
  • Monmouthshire, in Wales: Five Lanes or Llanfoist take small household amounts by booked slot. Mitchel Troy does not.
  • Powys, in Wales: check with the council before moving any.

HSE says to "use a lockable skip for asbestos". Anything licensed is handed to a licensed firm. For suspect rainwater goods, the first step is photographs and a survey, not a hammer. Do not drill, scrub or jet wash a grey pipe you are unsure about.

Clearing, repairing or renewing: what sets the price

Many drainage faults need a clear-out, not a new pipe. Which? gives £75 to £350 to clear the gutters, front and back (November 2025 survey, ex VAT). A blocked pipe can be cleared from a ladder, and a leaking joint can be resealed. Renewal comes in where the pipe is split, the brackets are rusted away or the wall behind needs attention.

For larger work, MyJobQuote gives gutter replacement as an average of £1,000 to £1,600, and standard uPVC at around £40 to £50 per metre. These are plastic figures, not ours, and they say nothing about iron or lead. Whether scaffold is needed depends on the height and the access, and a low run on a single storey can be reached from a ladder. A tower or full scaffold goes up where the pipe passes a window head or a roof valley.

You are given one written figure after the survey. These things move it:

  • the height of the house and the access to the wall
  • the number of downpipes, hoppers and bends
  • the material, and whether it matches an older pattern
  • whether the gully or the wall behind needs work
  • whether any suspect asbestos cement must be passed on

A quote should state whether VAT and scaffold are included, and each downpipe, hopper and gully that is dealt with should be named in it, so you can check them against the survey photographs. Where the scaffold stands over a public path or road, we arrange the licence with our scaffolder.

Downpipes and drains: your questions

What does a hopper do on a downpipe?

A hopper is the box or funnel at the top of a downpipe. It receives water from the gutter, and sometimes from a pipe at an upper floor, and gives it a wide mouth to fall into. If it blocks, water spills over the front and runs down the wall below, so it needs clearing as often as the gutter does.

Why is there a damp patch on the wall under my downpipe?

A joint may have separated, a bracket may have pulled away, or the pipe may be discharging onto the wall instead of into a gully. We check each from a ladder and photograph the wall. If the gully is blocked, the pipe backs up and soaks the wall base, so that is checked as well.

Could my old grey downpipe contain asbestos?

It could. HSE names rainwater goods among the asbestos cement products on its lists, and tells owners to assume asbestos in a building built or refurbished before 2000. Leave the pipe undrilled and unbroken, and send photographs. We look first and decide about removal afterwards, and a licensed firm is brought in if the work calls for one.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing