01432 610152 Get a quote Call 01432 610152

Damp on the breast

Why is there damp on my chimney breast?

A stain on a chimney breast can trace back to the stack top, the lead round its foot, a gutter nearby or a flue with no air moving through it.

In brief

Damp on a breast has more than one possible source. Rain can get in at the top of the stack through cracked flaunching or open joints, through failed lead at the stack's foot, or from a slipped tile or overflowing gutter close by. A flue that is closed off with no vent can also sweat inside. Looking at the stack from outside and from the loft, with photographs, shows which of these applies, and the repair then goes to the source rather than the stain.

Five routes by which wet reaches a chimney breast

A chimney breast is built up inside the house, but the stack it feeds stands in the open on the roof. Anything that lets wet into the stack, or into the roof round it, can leave a mark on the breast below. The routes are these:

  • the top of the stack: cracked flaunching, a pot that has loosened, or a cap that has failed
  • the faces of the stack: open joints and weathered brick or stone, which soak up rain on the side that takes the weather
  • the junction with the roof: lead flashings or soakers that have lifted, split or been pulled loose
  • the roof beside the stack: a slipped slate, a cracked tile or a blocked valley that sends water towards the stack
  • the flue itself: a closed-off flue where air no longer moves can lead to condensation and staining

These can overlap, which is why fixing only the part you can see may not settle it. Our page on why an unused chimney lets in rain follows one of them in detail.

What the position of the stain suggests

Where the mark sits on the breast is a clue, not proof. Treat the table below as a guide to where to look first, not a diagnosis made from the armchair:

Stain position and where a survey looks first
Where the mark showsWhere a survey looks first
High on the breast, near the ceilingThe flashing round the foot of the stack
Running down in a line from the loftThe stack top and its joints
Spreading near the hearthThe flue, its cap and any vent
Mark on one side of the breast onlyThe roof slope or gutter on that side

A stain that grows after rain and fades in dry spells is a different pattern from one that stays the same size all year. Note the dates when it changes and photograph it. That record helps us read the stack correctly, and helps an insurer if the damp followed a storm. If it followed a storm, speak to your insurer before permanent work starts, and hold on to the receipts for anything done to make the house safe in the meantime.

What the survey checks and what lead repairs cost

A survey starts outside, at the skyline,. We look at the pot, the flaunching, the joints on each face, the flashings and the slopes either side, and afterwards climb into the loft to see the back of the stack and the timbers round it. Everything is photographed, so you see what we found rather than hearing about it, and the pictures show the stain, the stack top and the lead from the same angles each time, which makes a later comparison easy if the damp comes back.

Lead round the foot of a stack gets close attention. MyJobQuote (page dated 22/09/26) gives around £200 for patching the lead on a chimney and around £570 for replacing it all, adding that lead installed correctly "can last for over 80 years". Those are averages for the UK, and our own figure is one total in writing, given when the survey is done.

If the cure involves re-covering part of the roof round the stack, the rules differ either side of the border. English re-roofing is judged by the Planning Portal against a limit on the building envelope and another on the roof. For Wales, the Welsh Government states that re-roofing will need Building Regulations approval in most situations, and on a Welsh house we start by asking the council's building control team.

A closed flue, a removed breast and an unused stack

An older house may have a flue that no fire uses any more. If its top is capped with no vent, damp air has nowhere to go and the inside of the breast can stay wet. Our page on whether a capped chimney should be ventilated deals with that fitting.

Some owners respond to damp by deciding to take the breast out. That is a structural job in its own right. The Planning Portal tells English owners that approval "will always apply" once a breast is to come out. In Wales, the Building Regulations are devolved, and we ask the council's building control service or a registered building control approver before any breast comes out. A breast shared with next door also brings in the Party Wall etc. Act 1996 in England and in Wales.

Taking the breast out does not cure rain entering at the top of the stack, so the outside repair is made first or alongside it. The chimney repairs hub shows how those jobs are put in order.

Related questions

Will new plaster on the breast cure the damp?

Not by itself. If rain or condensation is still reaching the breast, fresh plaster takes up the same moisture and the mark returns. The source at the stack, the lead or the flue is repaired first, then the wall is left to dry before it is redecorated.

Is damp on the breast always a roof fault?

No. A flue that is closed off with no vent can cause damp from the inside, and a gutter or pipe near the stack can send water towards it. A survey from the loft and the roof separates those causes from a fault in the stack itself.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing