In brief
It depends on the covering, and published figures do not always agree. HomeBuilding puts Welsh slate at 100 years or more. For clay tile the BRE set a minimum life of 60 years. Plain concrete tile is 40 to 50 years by HomeBuilding's table, against around 60 years from Marley. Flat coverings sit lower, from 10 to 15 years for felt up to 25 to 30 for EPDM. These are typical ranges, and the flashings, nails and bedding around a covering age at their own pace.
Typical lifespans by covering
The table gives each range beside the body that published it. Where two sources differ, both are shown, since the gap between them is real and worth seeing. Read the figures as the span a good roof can reach in ordinary use, with sound detailing and some upkeep along the way.
| Covering | Range | Source |
|---|---|---|
| Welsh slate | 100+ years | HomeBuilding |
| Spanish slate | 75-100 years | HomeBuilding |
| Reclaimed Welsh slate | 50-80 years | HomeBuilding |
| Concrete tile | Around 60 years, or 40-50 years | Marley, or HomeBuilding |
| EPDM | 25-30 years, or 30 to 50 years | HomeBuilding, or Less |
| GRP | 25-30 years, or 25 to 40 years | HomeBuilding, or Less |
| Felt | 10-15 years, or 10 to 20 years | HomeBuilding, or Less |
| Clay tile | 60 years minimum | BRE, via Marley |
SPAB's note on Wales and the Marches gives a well-slated roof a likely life of "more than 100 years". The BRE figure is a clay-tile one and is not extended to any other covering. A roof that mixes materials, such as a slate main slope with lead in the valleys and at the stack, is read part by part, since each part has its own range.
Why a roof does not age as one piece
A covering and the parts that hold it down are different ages and different materials. A slate roof may hang on nails that corrode long before the slate wears out, and once a nail goes, the slate drops out of line though it is perfectly sound. The bedding beneath a ridge, the lead at a chimney and the underlay under the battens each wear at their own rate.
Lead shows the point well. On leadwork, MyJobQuote says a correctly fitted flashing can last for over 80 years, a hedged claim that depends on the fitting and is no kind of floor. HomeBuilding's 60 to 100 years is for a lead flat roof, a separate job from a flashing. Neither number tells you what your own flashing has left in it.
Marley words its tile figure as an expectation. We read every lifespan in that spirit: it is what a well-made, well-fitted roof can reach, and nothing to rely on unseen. A survey tells you more than any table, because it records the real condition of your real roof, working down from the ridge.
Signs a roof is nearing the end of its range
Age alone settles nothing. What counts is how the roof behaves today. At a survey we look for these, and photograph each one we find:
- Slates or tiles that have shifted, split across or begun peeling in layers.
- Nail heads showing, or slates that move when pressed by hand.
- Ridge and hip bedding that has cracked or dropped away.
- Lead that has split, lifted or lost its dressing at a stack or valley.
- Daylight, damp patches or stained timbers when you look up in the loft.
- A flat roof with pools of standing water, blisters or lifting seams.
One or two of these points to a repair. A spread across several slopes suggests the fixings are failing more widely, and that is the moment to set out the photographs and weigh a repair against a re-cover. A roof that is sound apart from a single fault does not call for replacement, and where a repair is the sounder choice, the survey report says that plainly.
Our roof inspections page describes what a survey covers, and the photographs give each fault a date you can refer back to.
Repair, re-cover or replace: the rules on each side
When the end of the range arrives, the choice depends on how big a part of the roof has gone, and approval works differently depending on which side of the border you live.
- In England, where a re-roof touches less than 25 per cent of the total building envelope and less than 50 per cent of the roof, the Planning Portal advises that no application is normally required.
- In England, a covering that weighs 15 per cent or more than the old one brings Building Regulations approval, in the Planning Portal's words, and a structural check.
- In Wales, the Welsh Government states that re-roofing in most situations will need Building Regulations approval.
Swapping slate for tile, or tile for slate, changes both weight and appearance, so ask the council's building control team before you decide. Whichever route you take, the specification follows the construction of your house and the law of your own side.
For a written total price on either route, the page on what a written roof quote covers explains what to look for. The rest of our work is set out on the Horizon Roofing homepage.
