Callout 1 of 3
The ridge over Shobdon's tile and slate
We begin at the highest point. A Shobdon ridge is a row of capping tiles over the seam where the two main slopes join, either laid on a mortar bed or held with clips and screws. In 1934 the Royal Commission on Historical Monuments gave monuments 3 to 23 in Shobdon parish a single description, unless an entry said otherwise: buildings of the 17th century, two storeys high, timber-framed, with "tile or slate-covered roofs". Over ninety years have passed since that note was made, and only a close look at your ridge shows what the house wears now.
From one gable end to the other, we press down on the capping with a gloved hand. A tile that shifts has lost its bed. Hairline cracks in the bedding admit rain under the cap and into the top course, then down to the battens (thin laths of timber that hold each course in place). A hip, the sloping outer edge on which a ridge ends, is where two slopes part company; its joints take rain from two directions, so each one gets a second look.
On fixings, Marley's advice is direct: installing to BS 5534 "isn't required by law", yet the 2015 amendments ended mortar as the sole means of holding a covering down. BS 5534 governs slating and tiling, and BS 8612 covers dry-fix ridges. On a house built to be bedded, we put a mechanical fixing in beside the mortar and keep the traditional look, so the ridge reads from the lane as it always has.
Our report names each tile or joint that needs work, shows it in a photograph and says whether a repair will hold. Wherever mending will serve better than renewing, the report states that plainly. A loose ridge is a repair job and nothing more. If the entire covering is spent, remember that Shobdon sits in England, where the Planning Portal puts two questions to you: is less than 25 per cent of the building envelope affected, and is less than 50 per cent of the roof? Inside both limits, an application is not normally expected of you. If a new covering increases the weight by 15 per cent or more, approval is needed, after a structural check of the timbers. Our roof repairs hub covers the smaller jobs.
Ridge checks before any tile is lifted
- Capping tiles that rock or sit proud
- Mortar joints cracked or crumbling
- Fixings holding each capping tile
- The junction where ridge meets hip
- Gable-end tiles and their bedding
From the lane a ridge looks sound; up close, the bedding tells the real story.















