Callout 1 of 3
Gable verges where Kingsland's older roofs end
A gable verge is where the slope runs out. Along that last line the covering has air on both sides, so a gust that gets underneath tries to peel the units off one after another. From the ground we look for pieces that have crept out of line and for staining down the face of the gable. From the ladder we press the pointing, feel for movement and see how the covering sits against the wall. Anything loose is photographed before it is touched, so the picture you receive shows the fault as we found it, not as we left it.
The Royal Commission's inventory of 1934 deals with Kingsland's monuments 5 to 72 in one sweep. Barring the exceptions it notes, its verdict is buildings of the 17th century, two storeys high and timber-framed, with "stone, slate or tile-covered roofs". Three kinds of covering call for three kinds of verge finish, and the only way to learn which one your house needs is to go up and look. A verge system made for one covering is never pressed onto a roof of another.
Stone is the covering that sends us to a quarry rather than a merchant. According to the county's building stone atlas, the principal source of Herefordshire's stone roofing is the St Maughans sandstone, which a few quarries still work, while the active permissions it lists sit out west in the Golden Valley area. SPAB adds a warning of its own: if a supplier describes stone or slate as unobtainable or slow to arrive, the quarries themselves should be asked, because the answer is not always the same at source. We make that call before anyone proposes swapping the material for something easier to buy.
On the fixing side, Marley's position is that working to BS 5534 is voluntary in law, though since the 2015 amendments mortar alone is no longer accepted as the way of holding a covering. A mortar-bedded verge therefore receives mechanical fixings too, and BS 8612 covers dry-fix verge units that take mortar out of the picture altogether. Our roof repairs page describes the smaller verge and ridge jobs, and the site is cleared and the waste carried off once they are finished.
What we check along a Kingsland verge
- Verge pieces
- Firm, in line and fixed mechanically
- Pointing
- Sound, with no gaps along the run
- Wall junction
- Tight where covering meets the gable
- Gable face
- Dry, with no staining from above
Three coverings mean three ways of finishing a verge, and only a look settles which.















