Callout 1 of 3
Gable verges, mortar beds and dry-fix systems
The first callout is the verge, the edge of a roof where it overhangs a gable end. For Aymestrey parish the Royal Commission's 1934 inventory of Herefordshire describes the monuments it listed as seventeenth-century houses of two storeys, timber-framed, with roofs it calls "tile or slate-covered". Gables are common to buildings of that kind, and a gable is where the roof meets open weather on its side, with nothing behind it to share the load of a gust.
A verge is built one of two ways. The older way sets verge tiles or slates on a bed of mortar over an undercloak, a course of tile or slate laid beneath them to carry the run-off back onto the roof. The newer way clips or screws a dry-verge unit along the edge without mortar, and BS 8612 is the specification that covers dry-fix. Marley, the tile maker, says "Installing to BS 5534 isn't required by law", although mortar on its own is no longer treated as a fixing, so a mortar verge also gets a mechanical fixing now.
When a verge fails, the signs are easy to see from the lane. We look for:
- A mortar bed that has cracked, dropped or gone green
- Verge tiles that rock, or sit proud of their neighbours
- An undercloak that has slipped or split
- A gap where the roof meets the gable wall below
A gable that has lost its verge lets wind get under the edge tiles and lift them one by one, so a small repair done early saves a larger one. Our roof repairs page lists the jobs that follow from a survey.
At the top of the verge sits the ridge end, where the capping meets the verge line. That joint takes the full force of a gust, and a ridge end that has opened will undo a good verge, so we check it and rebed it on the same visit.
Where a gable wall is timber-framed, the verge also has to follow the movement of the frame. We rebed the verge to sit tight against the timber, and we note on the report where the frame itself looks to have moved, so you know whether the cause lies above or below the roof.
Mortar or dry-fix
Can a mortar verge be rebuilt with a dry-fix unit?
It can, where the roof edge is sound. A dry-verge unit fixes mechanically and BS 8612 covers it. On an older house we may keep the mortar look and add a clip, so the verge still reads as the original.
A gale needs one loose verge tile to start, and the rest of the edge follows it.















