01432 610152 Get a quote Call 01432 610152

Roofers in Norton Canon

Roof repairs and re-roofs for Norton Canon's timber-framed farmhouses, cottages and newer homes.

We climb to the verges and valleys first, then send photographs of each fault along with a price in writing.

Get a free quoteCall 01432 610152

Weak points on a Norton Canon roof

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Gable vergesWhere a frame gable moves, the edge of the covering can lift away.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Valley guttersBoth slopes feed one run of lead, so lining wear shows quickly.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Eaves and guttersA gutter that has dropped its fall leaves the timber below wet.

Norton Canon on our area map

Norton Canon on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Norton Canon roofs, gable to gutter

Verge, valley and eaves: three checks on a Norton Canon roof

Our survey runs from the gable ends to the valley lines and then down to the guttering, three stops that each have their own faults and their own fixes.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Verge; 2 Valley; 3 Eaves.

Fig. 1 A border house in section, numbered with Norton Canon's three callouts.

Callout 1 of 3

Gable verges on a seventeenth-century frame

We begin at the verge, the finished edge where a roof meets a gable wall. The Royal Commission's 1934 inventory dealt with the buildings numbered 2 to 25 in Norton Canon parish as a group, calling them timber-framed houses of two storeys and the 17th century, with "tile or slate-covered roofs" (barring exceptions it notes). Whatever has been laid since, the verge of a framed house is a spot where two things that move must stay sealed together: a wall that shifts with the seasons, and a covering that has to stay tight against it.

A traditional verge is bedded in mortar over the undercloak, a strip of slate or tile set beneath the edge to hold it clear of the wall face. Mortar cracks as a gable flexes, and once it falls out, wind can lift the edge tiles. A dry verge system, covered by BS 8612, grips the edge with mechanical units instead, and Marley says mortar "could no longer be relied upon as the only means of securing the roof covering". On an older gable we may keep a mortar bed for its look and fix behind it, or choose dry units where the edge is straight. We explain the choice before work starts.

From the lane we photograph both verges, then check them close up from the roof or a scaffold. Where mortar has fallen, the bare edge of the undercloak is photographed so the cause is clear. We look for daylight under the edge tiles, mortar lying on the ground, green staining down the wall below and tiles that have crept out of line. Frames settle unevenly, so we also sight along the ridge for dips that point to a fault further down the slope.

Norton Canon is about 19 minutes' drive from central Hereford, so a verge survey fits comfortably into one visit. If it shows that a whole slope is spent, the Planning Portal's test for England applies: a new covering normally needs no application when less than 25 per cent of the building envelope and less than 50 per cent of the roof is touched. Our pitched roofing page covers the full re-cover.

A question at the gable

Does a dry verge suit an old timber-framed gable?

It can, where the gable edge is straight and sound enough to take the clamps. On a gable that has bowed, a mortar bed with a mechanical fixing behind it follows the wall better. The survey photographs show which case yours is.

A verge that moves with the wall needs a fixing that can move with it.

Fig. 2 The verge, drawn close

Callout 2 of 3

Valley lines that gather two slopes

Valleys come second. A valley is the internal line where two slopes meet, so both of them empty into one narrow channel. That concentration is why a worn lining shows itself in the ceiling below before the rest of the roof does. Some valleys are open channels of lead with the tiles trimmed back on either side; in others the tiles are cut and swept round the curve, which is harder to inspect without lifting them.

A lead lining is one option, and Royston Lead's table shows which codes suit which job: Codes 4 to 8 are listed where a pitched valley gutter is being lined, while Code 3 is "Recommended for lead soakers only". We choose the thickness to fit the length of the run and keep the thin sheet for soakers. The lap joints, the upstands at each side and any split along a fold all get checked, because lead moves with temperature and a stiff fixing can tear it. Sealant over a split only postpones the failure. A new section dressed to move ends it.

Debris does damage here. Moss, leaves and silt collect in the channel and push water sideways under the tile edges. We clear a valley by hand with a brush and a scoop, and the pictures show the lining before and after. Where a batten beneath the tile edge has softened, it is cut out and replaced so the new lining has something firm to sit on. A valley that has been relined also gets a second look after the next heavy rain, from the ground if you ask us to, so any seep at a lap is caught early.

Our lead roofing page covers valley relining and the other leadwork on a roof in more detail, including the codes we pick for flashings and the way each joint is lapped.

Signs a valley is failing

  • A brown stain on the ceiling beneath
  • Lead that has split along a fold
  • Moss packed along the channel
  • Tile edges chipped beside the lining

Valley by valley

Lining
A lead code picked from Royston's table for valley use
Tile cuts
Edges checked for chips along the valley line
Debris
Leaves and moss cleared by hand with a brush
Battens
Softened timber cut out beside the lining

A relined valley stands or falls with the batten beneath it, so we check both.

Fig. 3 The valley, drawn close

Callout 3 of 3

Eaves, gutters and the tenants above them

Eaves are the lowest edge of each slope, where the roof reaches past the wall, and below them hangs the gutter, catching the run-off. Brett Martin, the gutter manufacturer, advises a fall of "1mm for every 600mm", so a length that sags between its brackets holds water, spills over the fascia and soaks the timber behind. We run a hand along each length, look for staining on the wall below and check the joints where sections meet. At every downpipe we examine the outlet and the drain, since a blocked outlet backs water up behind the gutter and into the fascia.

Roofs also have tenants. Under section 1 of the Wildlife and Countryside Act 1981, intentionally damaging, destroying or taking a wild bird's nest is an offence while the nest is in use or still being built. Bats of all species are protected as well, together with their breeding and resting places, and GOV.UK counts roof repairs and replacement among the work that may affect them, while Natural England grants the licences for English sites. If a survey finds signs of either at the eaves, the job is planned around that advice.

Norton Canon's listings shape the work. The Church of St Nicholas is Grade II* (list entry 1157795, first listed 2 September 1966), and Ye Olde Farmhouse is Grade II (list entry 1349516, first listed 16 July 1987). Section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 covers works that affect a listed building's character. Churches still holding services can follow a denominational route instead, the Church of England's faculty system being one. Staunton on Wye has a conservation area close by, and Herefordshire Council's list and maps cover all 64 in the county. Check whether an Article 4 direction applies with Herefordshire Council. The planning guide for roof windows covers any new opening.

Herefordshire Council Building Control, on 01432 261938, handles Building Regulations questions for properties here, and a private registered building control approver is the other choice. Our listed and heritage roofing page explains how we approach the older houses.

A gutter that holds water for a day is already failing.

Eaves words, in plain terms

Eaves
The lower edge of a slope, overhanging the wall below.
Fascia
The board fixed across the rafter ends that carries the gutter.
Soffit
The panel closing the underside of the overhang.
Fall
The slight slope that tells a gutter which way to drain.
Downpipe
The vertical pipe that takes gutter water to a drain.

Listings, lanes and licences near Norton Canon

What is looked at in a survey of a Norton Canon farmhouse roof?

We start at the verges and ridge, follow the valleys and stack flashings, then finish at the eaves and in the loft, where rafters, battens and underlay can be seen from below. Ye Olde Farmhouse in the village is listed Grade II (list entry 1349516, first listed 16 July 1987), so a roof like that also needs its consent route settled before a covering is lifted. Each fault is photographed and numbered in the report, so you can compare the pictures with what you see from the ground.

Which route approves roof work on a listed church such as St Nicholas?

St Nicholas is Grade II* (list entry 1157795, first listed 2 September 1966). The route turns on which body owns the church and on whether services continue in it. Anglican parish churches come under the faculty jurisdiction. The Methodist Church, the Roman Catholic dioceses and the United Reformed Church each run a system of their own, while Baptist Union churches are exempt only where a Schedule 1 trust corporation holds them. A closed church, or a chapel of the Unitarians or a Quaker meeting house, needs listed building consent.

Is Norton Canon inside a conservation area?

Staunton on Wye has a conservation area close to the village, and Herefordshire Council's list gives each boundary, so compare your address with it. The county has 64 in all. A conservation area weighs on a new dormer, and the council may also withdraw rights through an Article 4 direction, so check whether an Article 4 direction applies with Herefordshire Council before ordering a roof window.

What insulation standard applies if a Norton Canon roof is replaced?

In England, AD L 2021 Table 4.2 gives 0.15 for a new roof, and a roof window needs 1.4 or WER Band B. For the renovation of an existing roof, Table 4.3 gives a threshold of 0.35 and an improved figure of 0.16. AD L 2026 replaces these tables from 24 March 2027 as Tables 3.2 and 3.3, so the date of the building control application matters.

Who arranges a scaffold licence on a Norton Canon lane?

Highways Act 1980 section 169 requires a licence before scaffolding obstructs a highway. Herefordshire Council charges £167, covering a maximum of one month, then £123 for each extra month, with the application lodged at least 10 days before erection. We arrange the licence with our scaffolder, and its cost is folded into the one written total. National Highways, rather than the council, controls any trunk road or motorway.

Can work on a Norton Canon barn roof disturb bats or nesting birds?

Yes, it can. Intentional harm to a wild bird's nest is an offence while the nest is occupied or still going up, and bats are protected by law, together with their breeding and resting sites. Stripping or re-covering a barn roof can disturb both. If we see droppings, nests or access gaps at the eaves, work stops until the right advice, and any licence needed from Natural England, is in place.

Book a survey in Norton Canon, verge to gutter

Give us the roof's story in a message or a photograph, and we will survey from the verges down and write one total price.

10-year workmanship guarantee, in writing