01432 610152 Get a quote Call 01432 610152

Roofers in Hopton Wafers

Roof repairs, chimney work and outbuilding roofs around the listed Manor, the church and village houses.

Surveys begin at the chimney stacks; the report pairs each fault with a photo and sets one total in writing.

Get a free quoteCall 01432 610152

Stacks, outbuildings and listed rooftops

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Stacks with failing pointingOpen joints and cracked flaunching let rain into the stack and the room below.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Outbuilding eaves and guttersOutbuilding roofs shed water onto old walls when the gutters fail.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Listed church and manor roofsWork on a listed roof starts with the right consent, not with the scaffold.

Hopton Wafers at a glance

Hopton Wafers on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Hopton Wafers roofs, stack to eaves

Stacks, outbuildings and listings: three checks on a Hopton Wafers roof

Our survey climbs to the chimney stacks first, then follows the rain down to the eaves of the outbuildings, and ends with the listings, the church and the council lists that shape the repair.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Stacks; 2 Outbuilding eaves; 3 Listings and lists.

Fig. 1 A Hopton Wafers roof cut open: chimney, outbuilding eaves and roof window, each one numbered.

Callout 1 of 3

Chimney stacks, pots and flashings on listed houses

Hopton Wafers has a listed manor: The Manor is Grade II (list entry 1383551, first listed 12 November 1954), and the house entered on the list as The Village is Grade II too (list entry 1383553, first listed 15 March 1974). On an older house the stack is the tallest part of the roof, and each of its four faces takes wind and rain. We study it from the ground with binoculars, then from the ladder, working down from the pots and cowls to the flaunching and the pointing. Flaunching is the mortar fillet around the base of the pots, sloped so that rain runs off it and away from the flues. A crack between the fillet and a pot lets rain into the flue, and pointing worn back from the face of the stack leaves joints that hold water.

Lead seals the line where the stack rises out of the slope. We examine the flashings, which are lead strips tucked into the mortar joints and lapped over the covering, then the back gutter behind the stack and the soakers, the folded pieces of lead that go under each course up the sides. Split or lifted lead is replaced and not sealed over. In MyJobQuote's words, correctly fitted lead flashing "can last for over 80 years", which is a reason to keep lead that is sound.

A stack that has leaned or lost its top courses is a rebuild and not a repair. We take it down to a sound level, keep the good bricks or stones for reuse and lay it back to the profile it had. On a listed house the shape and the material are agreed with the council first, so the stack on the skyline is the stack that goes back up.

After the visual check comes the hands-on one. We press a screwdriver tip into the pointing to find mortar that crumbles, tap the brickwork for hollow sounds, and rock each pot to learn whether its bedding still holds. A stack that looks sound from the lane can carry a loose pot or a hollow collar, and both are simpler to put right while the rest of the stack is still sound. Our chimney repairs hub covers rebuilding, repointing and capping in more depth, and the photographs we send show each face of the stack, including the faces nobody can see from the ground.

A Hopton Wafers stack, part by part

Pots and cowls
Cracks, loose bedding and blocked tops
Flaunching
The mortar fillet sloping water off the flues
Pointing
Joints worn back from the stack face
Flashings
Lead tucked into joints and lapped over the covering
Soakers
Folded lead under each course at the sides

Nothing on a roof is harder to see from below than the top of a chimney stack.

Fig. 2 Chimneys, drawn close

Callout 2 of 3

Outbuildings, eaves and rainwater beside the Manor

The Outbuildings North East of the Manor are listed Grade II as well (list entry 1383552, first listed 12 November 1954). On any outbuilding the eaves are where the roof, the wall and the gutter meet, so that is where the survey spends its time. We walk the line of the wall below the eaves, because a stain running down the stonework shows where a gutter has spilled for a long while, and we sight along each run to see whether it still falls towards its outlet. Brett Martin, a gutter manufacturer, advises "1mm for every 600mm".

Behind the gutter sit the fascia, the board that carries it, and the soffit, the boarding under the overhang. We prod both with a bradawl, a small pointed tool, to find soft timber, and from inside we check the rafter feet. A stop end is the cap that closes a gutter run, and when one goes missing the whole run empties at the corner. Water poured down each downpipe shows whether it carries the flow away or backs up at a joint.

The HSE says: "If the building was built or refurbished before 2000, assume that there is asbestos in it." On an outbuilding that can mean cement sheeting on the roof or white boards under the eaves. Old cement sheets are brittle and can break under a footstep, a point the HSE makes about every asbestos cement roof, so we work from crawling boards or a platform and put no weight on the sheets themselves. Cement sheet lifted off carefully, without breaking, is non-licensed work, but insulating board, found behind some white fascia and soffit panels, is usually licensed to remove, and a licensed firm is called in for that part of the work. Any asbestos that comes off leaves in a lockable skip, as HSE asks.

Outbuildings also change use, and the roof has to follow, whether the building is a workshop, a store or a room that is now lived in. A range turned into a workroom or a spare room needs its roof assessed for insulation and for ventilation, not just for weather. Our gutters, soffits and fascias hub covers the systems we fit and repair. Where a wall is stained or green below the eaves, the gutter is the first suspect, and mending it stops the damage before the masonry needs attention.

Checked at an outbuilding's eaves

  • Gutter fall towards each outlet
  • Brackets, joints and stop ends
  • Fascia and soffit, probed for softness
  • Rafter feet, seen from inside
  • Wall face below the gutter line
Fig. 3 Eaves and gutters, drawn close

Callout 3 of 3

Listed roofs, the church and the council's own lists

St Michael's church carries a Grade II* listing (list entry 1383537, first listed 12 November 1954). Its roof work follows the Church of England's faculty system for as long as the building stays in use for worship, and the council's consent route does not apply. A listed house is another matter. The 1990 Planning (Listed Buildings and Conservation Areas) Act, in section 7, brings any work touching a house's "character as a building of special architectural or historic interest" under consent, on top of the permitted development rights the house keeps. Matching the old covering, pointing and ridge detail is the first conversation with Shropshire Council.

Shropshire Council keeps the conservation area list, and its pages are the place to check an address in Hopton Wafers. Ask the council whether an Article 4 direction applies to your house too: where one is in force, specified permitted development rights are withdrawn across the area it covers, and a roof job can then need an application that it would not need elsewhere. We put both questions to the council at the start of any listed or heritage job.

How a roof window or a dormer fits the rules in England depends on the house and where the window sits, and our planning guide for roof windows walks through each case. Building control for a re-roof or a conversion comes from Shropshire Council Building Control, on 01743 258710, or from a registered building control approver. A scaffold on the road needs a highway licence, and we arrange the licence with our scaffolder.

Hopton Wafers is 29.7 miles by road north of central Hereford, about 43 minutes of driving, and the nearest station is Ludlow. Our listed and heritage roofing hub explains how a listed roof is surveyed and repaired, and every step comes with photographs you can hand to the council.

Before work on a listed roof

Who should I ask before any roof work on a listed building?

Ask the council about listed building consent for a house, or the church's own governing body for a church. Photographs of the roof as it stands go with the request, so it shows exactly what is there and what is proposed.

Hopton Wafers roofs: listings, stacks and council lists

Can a listed Hopton Wafers house keep its old covering when the roof is repaired?

Keeping the old covering is where the conversation with the council starts. Consent is needed for any works touching a listed house's character, and a repair that matches the roof as it stands is agreed with Shropshire Council before work begins. SPAB's note on slate and stone roofs says a claim of unavailability "should always be checked with the quarries", and the quarries get that question before a substitute is proposed.

Who approves roof work at the Church of St Michael in Hopton Wafers?

St Michael's is listed Grade II* (list entry 1383537, first listed 12 November 1954). Being a Church of England building that holds worship, it sits inside the faculty system, so roof work goes through that church process and not through listed building consent from the council. Start by asking the church's own governing body, which holds the process, and we work to whatever the church's advisers approve.

How do I find out if my Hopton Wafers house is in a conservation area?

Shropshire Council keeps the list of conservation areas, so check it for your own address rather than assume, because the answer shapes what the survey recommends. The Article 4 question is separate, and the council answers that too: such a direction can remove specified permitted development rights across its area. We put both questions at the survey, since the answers decide whether an altered covering needs an application.

What do you photograph on a Hopton Wafers chimney stack?

Each of the four faces gets its own pictures, along with the pots and cowls, the flaunching, the pointing and every lead flashing and soaker. Pictures of the faces you cannot see from the ground are the most useful, because they show whether the stack needs repointing, a new collar or a rebuild. The report puts the photographs beside the written findings, so you can judge the fault before you agree to any work.

Which licence applies if scaffold goes up on a Hopton Wafers lane?

The Highways Act 1980 (section 169) prohibits scaffolding on the highway without a licence. Shropshire Council's 2026/27 fees page lists £200 for the scaffolding or hoarding licence, and the application is due ten working days ahead of erection, Saturdays excluded. We arrange the licence with our scaffolder, and the scaffold is already inside the single total we write out after surveying the roof.

What U-value must a renovated Hopton Wafers roof reach?

Under AD L 2021 Table 4.3, a renovated roof is brought to 0.16 W/m²K, with 0.35 as the threshold for the retained roof. Where 0.16 cannot be reached, paragraph 4.13 points to the lowest figure that is feasible and pays back within 15 years, and a thermal element once upgraded should generally not exceed 0.7. AD L 2026 Table 3.3 replaces the table from 24 March 2027.

Book a stack-first survey in Hopton Wafers

Tell us about the chimney, the outbuilding or the listed roof in a message or a photo, and a survey date follows.

10-year workmanship guarantee, in writing