Callout 1 of 3
Where a black-and-white wall meets its roof
The first callout is the join between wall and roof. The Herefordshire building stone atlas lists Dilwyn among the Black and White Villages north-west of Hereford, "notably Eardisland, Pembridge, Almeley, Dilwyn, Yarpole and Weobley". Of all the building styles in this rural county, the atlas singles out the black-and-white, timber-framed house as "most striking", above all in the north-western quarter. A roof on such a house has to meet a timber wall, and that meeting is where we begin.
The Royal Commission's 1934 volume on Herefordshire covers Dilwyn parish. For its monuments 7 to 60 it says they "are of the 17th century and of two storeys, timber-framed and with tile or slate-covered roofs". That describes the buildings it recorded, and tells us nothing about the covering on yours today. Coverings are renewed over the centuries, so each roof is read on its own. A house that looks old from the street can carry a newer covering on older timbers, and the reverse is just as possible.
Down at the eaves, our eyes go to the first courses above the wall plate, the timber that runs along the head of each wall and carries the rafters. At each gable we look at the verge, where the covering ends against the framing. We photograph both from close range and from a distance, so the report shows the fault and also where it sits. A gap between covering and timber is recorded with a scale, so you can see how wide it is.
If the covering needs renewing, pitch decides what can go on. Marley's table lists clay tiles by product, with minimum pitches of 40 degrees for Canterbury, 35 for Ashdowne, 30 for Hawkins and Acme Single Camber, and 15 for the Lincoln pantile. Its plain concrete tile needs 35 degrees. Those are product names, not regions, and the maker's data sheet always has the last word. We read the pitch on site before a covering is suggested.
Our pitched roofing page sets out the coverings and fixings we use. Dilwyn is in England, so the Planning Portal's two-part test applies to a re-cover: below 25 per cent of the building envelope and below 50 per cent of the roof, an application is not normally called for, and bigger work goes to building control.
Checked where wall meets roof
- Eaves courses above the wall plate
- Verge units and bedding at each gable
- Gaps between the covering and the timber
- Flashings against any brick or stone return
- Underlay laps along the eaves
A gap between covering and timber is photographed with a scale beside it, so the width is on record.















