Callout 1 of 3
Where a slope meets a rubble wall
The first callout is the line where a roof slope ends up against a wall that stands taller than the slope. The Royal Commission's 1932 inventory of Herefordshire, in its Walford-on-Wye entry, said of the monuments it listed that "the walls are of rubble and the roofs are tile or slate-covered". Rubble is stone laid as found, in courses that are never perfectly level. Such a wall gives a roof an uneven edge to seal against, and the seal is the weak point of many a covering that is sound everywhere else.
The seal is lead. A flashing is a strip whose top edge sits in a joint cut into the wall, called a chase, while the bottom edge laps down over the covering. Where the roof steps down along the wall, the flashing steps too, and a soaker, a bent lead tab, sits beneath every course next to it. Royston Lead's brochure lists Code 4 for soakers and flashings, Codes 5 and 6 for flashings but not soakers, and Code 3 for soakers alone. The report records the code that was used and the one we would use.
Faults arrive in a handful of ways, and the survey checks each in turn:
- Chase mortar that is sound, crumbling or missing
- Lead with lifted edges, splits at the steps or thin patches
- Soakers present under every course, or absent
- The wall face, for damp marks, loose stones and open joints
We check these with a visit to the roof surface and a second look after climbing into the loft, where a damp patch on the stone can show that a flashing has failed above it. A bead of sealant put on years ago to stop a drip hardens and cracks. Lead should be dressed back into the joint, with the wall repointed first when the chase has gone.
MyJobQuote says correctly installed lead flashing "can last for over 80 years", a hedged figure and not a promise, so a flashing that has merely lifted is worth saving. Our lead roofing page describes flashings, valleys and soakers. Where we find damp in the wall itself, we send you the photographs along with the roof report, so you can show them to whoever deals with the masonry. Loose stones in the wall face beside the lead are listed in the report as well, because new pointing cannot hold against a stone that moves.
Wall junction terms
- Chase
- A groove cut in the wall to take the lead
- Step flashing
- Lead cut in steps to follow a sloping wall line
- Soaker
- A bent lead tab slipped under each course
- Abutment
- The line where a roof ends against a wall
A flashing set into a sound joint outlasts any bead of sealant laid over it.















