01432 610152 Get a quote Call 01432 610152

Roofers in Little Birch

Roof repairs and re-roofs for Little Birch, 6.7 road miles south of Hereford.

Each survey establishes the roof's material and how it falls, and you receive photographs and one written total.

Get a free quoteCall 01432 610152

A small parish and its older roofs

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Pitch against coveringA tile or slate below its minimum pitch lets rain blow under the laps.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Ponding on flat roofsStanding water on an extension shows that the fall or the deck has failed.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Nests at the eavesBirds and bats use roof edges, so repairs there are planned around them.

Little Birch on the area map

Little Birch on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Little Birch roofs, pitch to eaves

Reading a Little Birch roof: the slope, the flat extension and the eaves

Our Little Birch survey takes the main slope first, then any flat-roofed extension or outbuilding, and ends at the eaves, where the older buildings and the church bring consent and wildlife questions.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Pitch and covering; 2 Flat roof; 3 Eaves and church.

Fig. 1 Section through a border house, with the three callouts for Little Birch numbered.

Callout 1 of 3

Pitch, covering and weight on a Little Birch slope

Callout one is the slope: the broad plane of covering that makes up most of a roof. Little Birch is a small parish. At the 2021 Census it had 207 usual residents, and its houses, farm buildings and church were built at different times, so we find out what is on each roof and do not guess from the next one along. A slope is read from the ground first, then close up from a ladder or scaffold: slipped or cracked units, lifted edges, moss that holds water against the covering, and dips where a batten has given way.

Pitch decides which coverings can go back on a slope. Marley's table gives each tile its own minimum pitch, listed by product name and not by region. Its Plain concrete tile is listed at 35 degrees, its Mendip 12.5 at 12.5 degrees and its Canterbury clay tile at 40 degrees. For natural slate, Cupa says BS 5534:2014+A2:2018 indicates a minimum pitch of 20 degrees for a project in an area with moderate exposure, a slate 500mm long and a 115mm overlap, and advises against hook fixings anywhere under 25 degrees of pitch. So we measure the pitch before we talk about a new covering, and read the data sheet from the maker for that tile.

Lifespan is a range and never a promise. Marley says roof tiles "are expected to last for around 60 years", while HomeBuilding gives plain concrete tiles "40-50 years". The BRE's 60-year minimum belongs to clay tiles only, and HomeBuilding puts Welsh slate at "100+ years". A range like that is a reason to repair a sound slope without stripping it, and a reason to say so plainly when a covering is spent.

Weight needs care once a new covering is chosen. As the Planning Portal sets out, building control must approve a new covering that adds 15 per cent or more to the roof load, and the rafters need a structural check before the order is placed. Our pitched roofing page lists the coverings and fixings on offer, and each fault we find on your slope is photographed with its position noted from the ridge down.

Minimum pitches as makers publish them

Marley Plain concrete tile
35 degrees
Marley Mendip 12.5
12.5 degrees
Marley Canterbury clay tile
40 degrees
Natural slate, per Cupa
20 degrees, within the conditions it sets out
Slate hook fixings
Not used on any pitch below 25 degrees

Pitch is measured first, because it decides what a slope can carry.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Flat roofs over an extension, garage or porch

Callout two is the flat roof. In a village it may cover a rear extension, a garage or a porch, and it needs a different way of reading from a slope. A flat roof is never level in the strict sense; it is laid with a fall that sends water away, and that fall is the first thing we check. BS 6229:2025 is the standard now in force for roofs finished with flexible waterproof membranes, and it replaced the 2018 edition, which was withdrawn on 16 December 2025. The trade body NFRC reads it as asking for "a minimum 1:80 finished fall for general roof areas and internal gutters". IKO, a membrane maker, advises designing the roof to a 1:40 fall in order to reach 1:80.

Standing water that stays for days after rain is the sign of a failed fall or a sagging deck. Beyond that we examine the laps, the upstands where it turns up the wall, and the edge trims. We lift the covering at a suspect corner to see the deck beneath, and from inside we look at the ceiling for stains, because a membrane can look sound while the boards under it have held water for a long time.

Coverings differ in how long they are expected to last, and the figures differ from one guide to the next. HomeBuilding gives EPDM "25-30 years" where Less gives "30 to 50 years". For GRP the two give "25-30" and "25 to 40", and for torch-on felt "10-15" and "10 to 20". We set out both figures for you, with our view of which fits your deck and its use. A patch can be right where a membrane is sound but pierced in one place. Where the covering is crazed all over or the boards have softened, a patch only delays the bigger job, and the report says so.

Because a roof is classed as a thermal element, Part L can reach a new waterproof layer over a heated room. Our flat roofing page explains EPDM, GRP and felt side by side, and what each asks of the deck beneath.

Price drivers on a Little Birch flat roof

Roof area and shape
More area and more corners take more membrane and trim
Deck condition
Boards that have softened add carpentry before any new layer
Covering chosen
EPDM, GRP and felt differ in material and in how they are laid
Access
Height and the route for materials decide the scaffold and the labour
Outlets and edges
Gutters, drips and upstands at the low edge are part of the job

One written total price, never itemised.

Fig. 3 Flat roofs, drawn close

Callout 3 of 3

Church roofline, nesting birds and bats at the eaves

Callout three is the eaves, where the older roofs of the parish meet the wall and the weather. St Mary's Church at Little Birch carries a Grade II* listing (list entry 1348854, first listed 21 May 1987). Who signs off roof work on St Mary's comes down to two facts: which body owns it and whether worship continues there. A working Anglican church follows the faculty procedure of the Church of England, and the exemption also reaches working churches of the Methodists, the Catholic dioceses, the URC and Baptist Union congregations, these last only where a Schedule 1 trust corporation holds the building. Every other place of worship, and any church that has closed, goes to the council for listed building consent. For a listed house, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 requires consent for work that touches its special architectural or historic interest.

Eaves are also where birds nest and bats can roost. Under the Wildlife and Countryside Act 1981, anyone who deliberately damages the nest of a wild bird, whether still under construction or already lived in, has committed an offence. For bats, GOV.UK warns that roof repair or replacement can affect them, and that their breeding sites and resting places have full protection in law. Natural England issues the licences in England. The Habitats Regulations 2017 go further: damage to a roost can break the law even where nobody meant any harm.

So the survey looks for signs: droppings below a gap, staining at an entry point, old nesting material. If we find any, work in that stretch stops and we tell you before anything is disturbed, because the next step is a question for Natural England and not for us to settle on a ladder. Nothing about a nest or a roost makes a repair impossible. It means the repair is planned around them.

Look up your street in Herefordshire Council's own conservation area list, and ask Herefordshire Council whether an Article 4 direction applies to it. Our listed and heritage roofing page describes how we approach older and protected buildings.

Terms for a Little Birch roofline

Eaves
The lowest edge of the roof, where it overhangs the wall
Faculty
The Church of England's consent system for works to its churches
Roost
A place a bat uses for shelter, protected even when empty
Article 4 direction
A council order withdrawing certain permitted development rights in an area

Little Birch roofs: pitch, flats and the church

What should be checked on a Little Birch roof before a new covering is chosen?

Three things come first: the pitch, the weight and the state of the timbers underneath. The pitch must suit the tile or slate, because each has a minimum in its maker's data sheet. A heavier covering can bring in Building Regulations approval and a structural check. Rafters and battens are examined from the loft, so any rot is found before new material goes on top.

Can a swallow or house martin nest at a Little Birch eaves hold up a repair?

It can change the timing of the work without cancelling it. The law targets anyone who intentionally harms a nest the birds are occupying or still putting together, so we leave an active nest alone, plan the rest of the roof around it and return to that stretch once the birds have finished. Any nest we cannot reach safely is photographed and left alone until the birds have gone.

Does a flat roof on a Little Birch extension need a particular fall?

For flexible membranes, BS 6229:2025 applies, and NFRC reads it as asking for a minimum 1:80 finished fall. IKO advises designing for 1:40 so that 1:80 is reached. We measure the fall with a level before and after the work, and the report tells you what we found at each outlet, so any standing water has a reason on paper.

Is Little Birch in a conservation area, and does an Article 4 direction apply?

Search Herefordshire Council's own conservation area list for your street, because the list and the boundary maps belong to the council. There are 64 conservation areas in Herefordshire, and a house inside one has different planning rules for some alterations. Ask Herefordshire Council whether an Article 4 direction applies to your address as well. A direction is a local order that removes particular permitted development rights from houses in a defined area.

What do third-party guides give for a roof survey on a Little Birch house?

MyJobQuote puts the average roof survey at around £300, with a basic visual inspection at £100 to £200, a full survey at £250 to £400 and a drone survey at £200 to £350. Those are national figures, not our prices. What a survey costs on your house depends on its size and the access, and the written price for any work follows the survey.

Who signs off a Little Birch re-roof under the Building Regulations?

Herefordshire Council Building Control on 01432 261938, or a registered building control approver. Little Birch is in England, so the Planning Portal test is used: under 25 per cent of the building envelope and under 50 per cent of the roof means an application is not normally needed. Larger work needs one, and any insulation added at the same time reaches Part L, which sets the figures the new roof must meet.

Ask for a pitch-first survey in Little Birch

Tell us which part troubles you, slope, flat roof or eaves, attach a snapshot if there is one, and a visit gets booked.

10-year workmanship guarantee, in writing